Ads
related to: 8x6.5 to 8x170 hub centric connector socket
Search results
Results From The WOW.Com Content Network
GG45 is a variant of ARJ45 that allows for cables terminated with male 8P8C (AKA RJ45) connectors to be plugged into GG45 jacks. However, GG45 cables cannot plug into 8P8C jacks as a protrusion on the socket is designed to activate a switch on the jack for the alternative contact positions. [2]
37.5–66 MHz Socket 7: 1994 Intel Pentium Intel Pentium MMX AMD K6: PGA: 321 ? 50–66 MHz It is possible to use Socket 7 processors in a Socket 5. An adapter is required, or if one is careful, a socket 7 can be pulled off its pins and put onto a socket 5 board, allowing the use of socket 7 processors. Socket 8: 1995 Intel Pentium Pro: PGA ...
The pilot pin is located in the centre of main contact circle on 4- and 5-pin connectors. On 3-pin (2P+E) connectors, it is located on the contact circle opposite the ground pin. The other connectors are located 105° on either side of the earth pin, rather than 120° as in the smaller variants, to make room for the pilot pin.
One such in somewhat common use was the VHDCI (Very High Density Cable Interconnect) connector, also known as an "AMP HPCN68M", and sometimes as "SCSI-5". There are 68 pins on the connector in two rows; the pins are 0.8 mm apart. This connector is reputed to suffer fewer bent pins than the 68-pin SCSI-2 connector despite its minuscule pins.
It is very common in blogs and websites to incorrectly name a specific connector only by the name of the manufacturer. To minimize confusion, it is best to describe a connector using: the manufacturer's name, exact connector series, and optionally the pitch, such as "JST-XH" or "JST-XH-2.50mm" or "2.50mm JST XH-series" or other variations.
Hubbell Incorporated, headquartered in Shelton, Connecticut, is an American company that designs, manufactures, and sells electrical and electronic products for non-residential and residential construction, industrial, and utility applications.