Search results
Results From The WOW.Com Content Network
A 2.26 kΩ, 1%-precision resistor with 5 color bands (), from top, 2-2-6-1-1; the last two brown bands indicate the multiplier (×10) and the tolerance (1%).. An electronic color code or electronic colour code (see spelling differences) is used to indicate the values or ratings of electronic components, usually for resistors, but also for capacitors, inductors, diodes and others.
A small, early 1960s-vintage motor control center for 480 volt motors. A motor control center ( MCC ) is an assembly to control some or all electric motors in a central location. It consists of multiple enclosed sections having a common power bus and with each section containing a combination starter, which in turn consists of motor starter ...
A BIOS Color Attribute is an 8 bit value where the low 4 bits represent the character color and the high 4 bits represent the background color. The name comes from the fact that these colors are used in BIOS interrupts, specifically INT 10h, the video interrupt. When writing text to the screen, a BIOS color attribute is used to designate the ...
Single-stage vacuum pumps typically produce vacuum to 35 torr (mm Hg) or 47 millibars (4.7 kPa), and two-stage pumps can produce vacuum to 25 torr, assuming air is being pumped and the ring-liquid is water at 15 °C (59 °F) or less. Dry air and 15 °C sealant-water temperature is the standard performance basis, which most manufacturers use for ...
Center-tapped delta transformer Center-tapped delta transformer voltages. High-leg delta service is supplied in one of two ways. One is by a three-phase transformer (or three single-phase transformers), having four wires coming out of the secondary, the three phases, plus a neutral connected as a center-tap on one of the windings.
The siphon may be primed by closing the intake and outlets and filling the siphon at the crest. If intakes and outlets are submerged, a vacuum pump may be applied at the crest to prime the siphon. Alternatively the siphon may be primed by a pump at either the intake or outlet. Gas in the liquid is a concern in large siphons. [30]
The general public may consider household mains circuits (100 to 250 VAC), which carry the highest voltages they normally encounter, to be high voltage. Voltages over approximately 50 volts can usually cause dangerous amounts of current to flow through a human being who touches two points of a circuit, so safety standards are more restrictive ...
Mullard initially handled semiconductor naming by using the "O" heater code (shifting "Cold Cathode" to a code of "Z"). The second letter broadly indicated the type of device, roughly following the tube designation, without indicating the semiconductor material: A low-power semiconductor diode, e.g. OA7