Search results
Results From The WOW.Com Content Network
The modem connects to a single computer or router, through an Ethernet port, USB port, or is installed in a computer PCI slot. The more common DSL router is a standalone device that combines the function of a DSL modem and a router, and can connect multiple computers through multiple Ethernet ports or an integral wireless access point.
This status light is directly coupled with what the modem is sending the DCD line. By default, when a modem is powered up, the DCD signal is deasserted. It is not asserted until the modem either makes an outgoing call, or answers an incoming call, and then connects with a data modem on the other end.
A DSL modem, which is type of customer-premises equipment. The WAN interface of this device, in this case the DSL port, could expose CWMP to the internet service provider . Technical Report 069 ( TR-069 ) is a document by the Broadband Forum that specifies the CPE WAN Management Protocol ( CWMP ).
It also acts like a dynamic host configuration protocol (DHCP) to assign IPs automatically to devices connected to the network. There are two kinds of wireless gateways. The simpler kind must be connected to a DSL modem or cable modem to connect to the internet via the internet service provider (ISP).
However, a modem generally provides few other network functions. A USB modem plugs into a single PC and allows a connection of that single PC to a WAN. If properly configured, the PC can also function as the router for a home LAN. An internal modem can be installed on a single PC (e.g. on a PCI card), also allowing that single PC to connect to ...
Convergence is the state of a set of routers that have the same topological information about the internetwork in which they operate. For a set of routers to have converged, they must have collected all available topology information from each other via the implemented routing protocol, the information they gathered must not contradict any other router's topology information in the set, and it ...
Simply put: You cannot run a red light if it’s taking too long to turn green. If you do, you risk being cited by law enforcement, according to California Vehicle Code 21453.
Some devices with dual-band wireless network connectivity do not allow the user to select the 2.4 GHz or 5 GHz band (or even a particular radio or SSID) when using Wi-Fi Protected Setup, unless the wireless access point has separate WPS button for each band or radio; however, a number of later wireless routers with multiple frequency bands and ...