Search results
Results From The WOW.Com Content Network
For example, UI is used to measure timing jitter in serial communications or in on-chip clock distributions. This measurement unit is extensively used in jitter literature. Examples can be found in various ITU-T Recommendations, [1] or in the tutorial from Ransom Stephens. [2]
Jitter period is the interval between two times of maximum effect (or minimum effect) of a signal characteristic that varies regularly with time. Jitter frequency, the more commonly quoted figure, is its inverse. ITU-T G.810 classifies deviation lower frequencies below 10 Hz as wander and higher frequencies at or above 10 Hz as jitter. [2]
Jitter is the undesired deviation from true periodicity of an assumed periodic signal in electronics and telecommunications, often in relation to a reference clock source. Jitter may be observed in characteristics such as the frequency of successive pulses, the signal amplitude , or phase of periodic signals.
Each time the peak-to-peak distance between the largest and smallest TIE in that window is noted. This distance varies as the window moves, being maximal for some window position. This maximal distance is known as MTIE for the given observation interval.
This of course means that the clock skew between two points varies from cycle to cycle, which is a complexity that is rarely mentioned. Many other authors use the term clock skew only for the spatial variation of clock times, and use the term clock jitter to represent the rest of the total clock timing uncertainty. This of course means that the ...
The counter implementation's accuracy is limited by the clock frequency. If time is measured by whole counts, then the resolution is limited to the clock period. For example, a 10 MHz clock has a resolution of 100 ns. To get resolution finer than a clock period, there are time interpolation circuits. [6] These circuits measure the fraction of a ...
Amongst the building blocks of a GPS Time and Frequency solution the oscillator is a key component [11] and typically they are built around an Oven Controlled Crystal Oscillator or a Rubidium based clock. The dominant factors influencing the quality of the reference oscillator are taken to be aging and temperature stability.
A prescaler is an electronic counting circuit used to reduce a high frequency electrical signal to a lower frequency by integer division.The prescaler takes the basic timer clock frequency (which may be the CPU clock frequency or may be some higher or lower frequency) and divides it by some value before feeding it to the timer, according to how the prescaler register(s) are configured.