Search results
Results From The WOW.Com Content Network
In computer networking, a port or port number is a number assigned to uniquely identify a connection endpoint and to direct data to a specific service. At the software level, within an operating system , a port is a logical construct that identifies a specific process or a type of network service .
Port forwarding via NAT router. In computer networking, port forwarding or port mapping is an application of network address translation (NAT) that redirects a communication request from one address and port number combination to another while the packets are traversing a network gateway, such as a router or firewall.
Figure 1: Example two-port network with symbol definitions. Notice the port condition is satisfied: the same current flows into each port as leaves that port.. In electronics, a two-port network (a kind of four-terminal network or quadripole) is an electrical network (i.e. a circuit) or device with two pairs of terminals to connect to external circuits.
An ephemeral port is a communications endpoint of a transport layer protocol of the Internet protocol suite that is used for only a short period of time for the duration of a communication session. Such short-lived ports are allocated automatically within a predefined range of port numbers by the IP stack software of a computer operating system.
The technical specifications of the 'non-PoE' and the 'PoE' models are the same in regards to switching capabilities and the main difference between the 24 and 48 port models is the total forwarding rate of the switch: 12,8 Gbit/s for both 24 port models and 17,6 Gbit/s for the 48 port models.
Within a layer 2 network, MVRP provides a method to dynamically share VLAN information and configure the needed VLANs. For example, in order to add a switch port to a VLAN, only the end port, or the VLAN-supporting network device connected to the switch port need be reconfigured, and all necessary VLAN trunks are dynamically created on the ...
A PPTP tunnel is instantiated by communication to the peer on TCP port 1723. This TCP connection is then used to initiate and manage a GRE tunnel to the same peer. The PPTP GRE packet format is non standard, including a new acknowledgement number field replacing the typical routing field in the GRE header. However, as in a normal GRE connection ...
NCP was a simplex protocol that utilized two port numbers, establishing two connections for two-way communications. An odd and an even port were reserved for each application layer application or protocol. The standardization of TCP and UDP reduced the need for the use of two simplex ports per application to one duplex port. [1]: 15