Search results
Results From The WOW.Com Content Network
Jitter is often measured as a fraction of UI. For example, jitter of 0.01 UI is jitter that moves a signal edge by 1% of the UI duration. The widespread use of UI in jitter measurements comes from the need to apply the same requirements or results to cases of different symbol rates. This can be d
Jitter period is the interval between two times of maximum effect (or minimum effect) of a signal characteristic that varies regularly with time. Jitter frequency, the more commonly quoted figure, is its inverse. ITU-T G.810 classifies deviation lower frequencies below 10 Hz as wander and higher frequencies at or above 10 Hz as jitter. [2]
It is used to specify clock stability requirements in telecommunications standards. [1] MTIE measurements can be used to detect clock instability that can cause data loss on a communications channel. [ 2 ]
Instantaneous packet delay variation is the difference between successive packets—here RFC 3393 does specify the selection criteria—and this is usually what is loosely termed "jitter", although jitter is also sometimes the term used for the variance of the packet delay. As an example, say packets are transmitted every 20 ms.
This of course means that the clock skew between two points varies from cycle to cycle, which is a complexity that is rarely mentioned. Many other authors use the term clock skew only for the spatial variation of clock times, and use the term clock jitter to represent the rest of the total clock timing uncertainty. This of course means that the ...
The stored data are used to control phase and frequency variations, allowing the locked condition to be reproduced within specifications. Holdover begins when the clock output no longer reflects the influence of a connected external reference, or transition from it. Holdover terminates when the output of the clock reverts to locked mode condition.
Clock synchronization is a topic in computer science and engineering that aims to coordinate otherwise independent clocks. Even when initially set accurately, real clocks will differ after some amount of time due to clock drift , caused by clocks counting time at slightly different rates.
When a program wants to time its own operation, it can use a function like the POSIX clock() function, which returns the CPU time used by the program. POSIX allows this clock to start at an arbitrary value, so to measure elapsed time, a program calls clock(), does some work, then calls clock() again. [1] The difference is the time needed to do ...