Ads
related to: main blades for rc helicopter videos
Search results
Results From The WOW.Com Content Network
Nitro RC helicopters are categorised under the following classes: 30 size : Engine 0.3 cubic inch, Main Blades 550-600mm; 50 size : Engine 0.5 cubic inch, Main Blades 600-620mm; 60 size : Engine 0.6 cubic inch; 90 size : Engine 0.9 cubic inch, Main Blades 690-710mm
In aeronautics, a swashplate is a mechanical device that translates input via the helicopter flight controls into motion of the main rotor blades. Because the main rotor blades are spinning, the swashplate is used to transmit three of the pilot's commands from the non-rotating fuselage to the rotating rotor hub and mainblades.
Sikorsky S-72 modified as the X-Wing testbed, with experimental 4-blade main rotor. With a single main rotor helicopter, the creation of torque as the engine turns the rotor creates a torque effect that causes the body of the helicopter to turn in the opposite direction of the rotor. To eliminate this effect, some sort of antitorque control ...
The main rear landing gear retracts into the sponsons. [2] The Bell 222's rotor systems include: Two-blade, semi-rigid high-kinetic energy main rotor with preconing and underslinging. The rotor head incorporates elastomeric bearings for hub springs, and flapping and pitch change bearings. The system is similar in design to that used by the AH-1 ...
A rotor blade produces more lift in the advancing half. As a blade moves toward the direction of flight, the forward motion of the aircraft increases the speed of the air flowing around the blade until it reaches a maximum when the blade is perpendicular to the relative wind. At the same time, a rotor blade in the retreating half produces less ...
A radio-controlled aircraft (often called RC aircraft or RC plane) is a small flying machine that is radio controlled by an operator on the ground using a hand-held radio transmitter. The transmitter continuously communicates with a receiver within the craft that sends signals to servomechanisms (servos) which move the control surfaces based on ...
An intermeshing-rotor helicopter (or synchropter) is a helicopter with a set of two main rotors turning in opposite directions, with each rotor mast mounted with a slight angle to the other, in a transversely symmetrical manner, so that the blades intermesh without colliding.
The rotorhead is where the lift force from the rotor blades act. The rotorhead is connected to the main drive shaft via the Jesus nut, and houses several other components such as the swash plate, flight control linkages and fly-bars. [1] The rotor hub is also where the centre of gravity acts on the helicopter. The rotor head of a Sikorsky S-92