Search results
Results From The WOW.Com Content Network
Steam stop valve - regulates the flow of steam that is produced in the boiler to the steam pipe, and may also be used to stop the supply of steam from the boiler Fusible plug - placed at the lowest level of water and above the combustion chamber, its function is to extinguish the fire as soon as the water level in the shell of the boiler falls ...
A steam boiler evaporates liquid water to form steam, or gaseous water, and requires frequent replenishment of boiler feedwater for the continuous production of steam required by most boiler applications. Water is a capable solvent, and will dissolve small amounts of solids from piping and containers including the boiler. Continuing evaporation ...
Piping and instrumentation diagram of pump with storage tank. Symbols according to EN ISO 10628 and EN 62424. A more complex example of a P&ID. A piping and instrumentation diagram (P&ID) is defined as follows: A diagram which shows the interconnection of process equipment and the instrumentation used to control the process.
Fire-tube boilers usually have a comparatively low rate of steam production, but high steam storage capacity. Fire-tube boilers mostly burn solid fuels, but are readily adaptable to those of the liquid or gas variety. Fire-tube boilers may also be referred to as "scotch-marine" or "marine" type boilers. [7] Diagram of a water-tube boiler.
The traditional form of steam donkey (as a mobile winch used in the logging industry) married a vertical boiler with a steam engine on a rigid base fitted with skids for mobility. Since the ground to be traversed would be rough and rarely level, the water-level -tolerant design of the vertical boiler was an obvious choice.
Cutaway section of a steam dome, showing the regulator inside. The steam dome is a vessel fitted to the top of the boiler of a steam engine.It contains the opening to the main steam pipe and its purpose is to allow this opening to be kept well above the water level in the boiler.
The separated steam flows through the overhead pipe (5) and the steam-water mixture flows through the collector pipe (3) to the drum (6) as well. In the drum occurs the final separation of steam from steam water mixture. The rest amount of water flows through the unheated return tubes (1) and downcomers (7) to the rear wall distributor/header ...
Boiler feedwater is the water which is supplied to a boiler. The feed water is put into the steam drum from a feed pump. In the steam drum the feed water is then turned into steam from the heat. After the steam is used, it is then dumped to the main condenser. From the condenser, it is then pumped to the deaerated feed tank.