When.com Web Search

  1. Ads

    related to: bolt size and head chart for cars for sale

Search results

  1. Results From The WOW.Com Content Network
  2. List of Ford bellhousing patterns - Wikipedia

    en.wikipedia.org/wiki/List_of_Ford_bellhousing...

    1.2/1.3/1.5/1.7L were mostly in European Cars. 1.8, 2.0/2.3 had the same bellhousings bolt patterns with differences from year to year to be wary of. The Mazda transmission 5M** does not "directly replace" the Mitsubishi transmissions as there are shifter spacing differences in the floorboard.

  3. List of GM bellhousing patterns - Wikipedia

    en.wikipedia.org/wiki/List_of_GM_bellhousing...

    The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission).

  4. Width across flats - Wikipedia

    en.wikipedia.org/wiki/Width_across_flats

    The two systems are in general not compatible, which can result in rounding of nuts and bolts (i.e. using a 13 mm (0.51 in) spanner in place of a 1 ⁄ 2 inch (12.70 mm)). A few sizes are close enough to interchange for most purposes, such as 19 mm (close to 3 ⁄ 4 inch (19.05 mm)), 8 mm (close to 5 ⁄ 16 inch (7.94 mm)) and 4 mm (close to 5 ...

  5. List of screw drives - Wikipedia

    en.wikipedia.org/wiki/List_of_screw_drives

    In Japan, the male sizes are often designated as DTC-20, DTC-27, DTC-40 (discontinued) and DTC-45 corresponding to a respective screw head size of 3.2 mm, 4.6 mm, 6.4 mm and 7.7 mm; with the size of the screw measured across the widest portion of the mating part of the head. The most common sizes in use for consumer electronics are DTC-20 and ...

  6. British Standard Whitworth - Wikipedia

    en.wikipedia.org/wiki/British_Standard_Whitworth

    To simplify matters, the term hexagon is used in this section to denote either bolt head or nut. Two spanners, both nominal size 5 ⁄ 8 in, with a diagram superimposed to show the logic that allows them both to be nominal size 5 ⁄ 8 in when their actual sizes are clearly different (across-flats distance vs screw diameter). The across-flats ...

  7. Dana 60 - Wikipedia

    en.wikipedia.org/wiki/Dana_60

    The Dana 53 first appeared in the late 1940s and is much like a Dana 60. Although all Dana 53s are semi-floating, rear axles, 9.25" ring gear diameter. It was used as OEM in 1960s full-size (C-body) Chrysler passenger cars equipped with the 440 CID engine. The Dana 53 was phased out in the late 1960s, replaced by the Dana 60.