When.com Web Search

  1. Ads

    related to: modified proctor test hammer weight loss

Search results

  1. Results From The WOW.Com Content Network
  2. Proctor compaction test - Wikipedia

    en.wikipedia.org/wiki/Proctor_compaction_test

    The original Proctor test, ASTM D698 / AASHTO T99, uses a 4-inch-diameter (100 mm) by 4.584-inch-high (116.4 mm) mold which holds 1/30 cubic feet of soil, and calls for compaction of three separate lifts of soil using 25 blows by a 5.5 lb hammer falling 12 inches, for a compactive effort of 12,375 ft-lbf/ft 3.

  3. Soil compaction - Wikipedia

    en.wikipedia.org/wiki/Soil_compaction

    The most commonly used laboratory test is called the Proctor compaction test and there are two different methods in obtaining the maximum density. They are the standard Proctor and modified Proctor tests; the modified Proctor is more commonly used. For small dams, the standard Proctor may still be the reference. [5]

  4. Geotechnical investigation - Wikipedia

    en.wikipedia.org/wiki/Geotechnical_investigation

    This test is used by Caltrans for pavement design, replacing the California bearing ratio test. Soil compaction tests Standard Proctor (ASTM D698), Modified Proctor (ASTM D1557), and California Test 216. These tests are used to determine the maximum unit weight and optimal water content a soil can achieve for a given compaction effort.

  5. Atterberg limits - Wikipedia

    en.wikipedia.org/wiki/Atterberg_limits

    The liquid limit test is defined by ASTM standard test method D 4318. [4] The test method also allows running the test at one moisture content where 20 to 30 blows are required to close the groove; then a correction factor is applied to obtain the liquid limit from the moisture content. [5]

  6. Schmidt hammer - Wikipedia

    en.wikipedia.org/wiki/Schmidt_hammer

    The rebound reading will be affected by the orientation of the hammer: when used oriented upward (for example, on the underside of a suspended slab), gravity will increase the rebound distance of the mass, and vice versa for a test conducted on a floor slab. Schmidt hammer measurements are on an arbitrary scale ranging from 10 to 100.

  7. Standard penetration test - Wikipedia

    en.wikipedia.org/wiki/Standard_penetration_test

    The test uses a thick-walled sampling tube, with an outside diameter of 5.01 cm (2 in) and an inside diameter of 3.5 cm (1.375 in), and a length of at least 60 cm (24 in). The sampling tube is driven into the ground at the bottom of a borehole by blows from a hammer with a mass of 63.5 kg (140 lb) falling a distance of 75 cm (30 in). The sample ...