Search results
Results From The WOW.Com Content Network
The "Drive-cycle" basically is the representative of the road. Drive cycles are used to reduce the expense of on road tests, time of test and fatigue of the test engineer. The whole idea is to bring the road to the test lab (a chassis dynamo-meter) or to the computer simulation. Two kinds of drive cycle can be made.
June 2019) (Learn how and when to remove this message) Drive Cycle Recognition (abbr. DCR) is an advanced vehicle control strategy that uses past driving information, as well as a library of representative drive cycles to extrapolate future vehicle control parameters.
It is also known as FTP-72 or LA-4, and it is also used in Sweden as the A10 or CVS (Constant Volume Sampler) cycle and in Australia as the ADR 27 (Australian Design Rules) cycle. [4] The cycle simulates an urban route of 7.5 mi (12.07 km) with frequent stops. The maximum speed is 56.7 mph (91.2 km/h) and the average speed is 19.6 mph (31.5 km/h).
The National Highway Traffic Safety Administration is investigating reports of alleged engine failures in GM's 6.2-liter L87 V-8, an engine used in a wide variety of trucks and SUVs.
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool.. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
The Worldwide Harmonised Light vehicles Test Procedure (WLTP) [1] is a global driving cycle standard for determining the levels of pollutants, CO 2 emission standards and fuel consumption of conventional internal combustion engine (ICE) and hybrid automobiles, as well as the all-electric range of plug-in electric vehicles.
Message Signaled Interrupts (MSI) are a method of signaling interrupts, using special in-band messages to replace traditional out-of-band signals on dedicated interrupt lines. While message signaled interrupts are more complex to implement in a device, they have some significant advantages over pin-based out-of-band interrupt signalling, such ...