Search results
Results From The WOW.Com Content Network
Loopback (also written loop-back) is the routing of electronic signals or digital data streams back to their source without intentional processing or modification.It is primarily a means of testing the communications infrastructure.
For example, the loopback address 127.0.0.1 was commonly written as 127.1, given that it belongs to a class-A network with eight bits for the network mask and 24 bits for the host number. When fewer than four numbers were specified in the address in dotted notation, the last value was treated as an integer of as many bytes as are required to ...
A multicast address is a logical identifier for a group of hosts in a computer network that are available to process datagrams or frames intended to be multicast for a designated network service. Multicast addressing can be used in the link layer (layer 2 in the OSI model ), such as Ethernet multicast, and at the internet layer (layer 3 for OSI ...
In Internet networking, a private network is a computer network that uses a private address space of IP addresses. These addresses are commonly used for local area networks (LANs) in residential, office, and enterprise environments.
In computer networking, localhost is a hostname that refers to the current computer used to access it. The name localhost is reserved for loopback purposes. [1] It is used to access the network services that are running on the host via the loopback network interface. Using the loopback interface bypasses any local network interface hardware.
Link-local addresses may be assigned manually by an administrator or by automatic operating system procedures. In Internet Protocol (IP) networks, they are assigned most often using stateless address autoconfiguration, a process that often uses a stochastic process to select the value of link-local addresses, assigning a pseudo-random address that is different for each session.
NOTE: a RID is the highest logical (loopback) IP address configured on a router, if no logical/loopback IP address is set then the router uses the highest IP address configured on its active interfaces (e.g. 192.168.0.1 would be higher than 10.1.1.2). Usually the router with the second-highest priority number becomes the BDR.
The loopback address is defined as 0000:0000:0000:0000:0000:0000:0000:0001 [40] and is abbreviated to ::1 by using both rules. As an IPv6 address may have more than one representation, the IETF has issued a proposed standard for representing them in text. [39]