Search results
Results From The WOW.Com Content Network
The figures below are simplex data rates, which may conflict with the duplex rates vendors sometimes use in promotional materials. Where two values are listed, the first value is the downstream rate and the second value is the upstream rate. The use of decimal prefixes is standard in data communications.
This is a list of TCP and UDP port numbers used by protocols for operation of network applications. The Transmission Control Protocol (TCP) and the User Datagram Protocol (UDP) only need one port for bidirectional traffic. TCP usually uses port numbers that match the services of the corresponding UDP implementations, if they exist, and vice versa.
In computer networking, a port or port number is a number assigned to uniquely identify a connection endpoint and to direct data to a specific service. At the software level, within an operating system, a port is a logical construct that identifies a specific process or a type of network service.
The "Server port" column indicates the port from which the server transmits data. In the case of FTP, this port differs from the listening port. Some protocols—including FTP, FTP Secure, FASP, and Tsunami—listen on a "control port" or "command port", at which they receive commands from the client.
It is typically measured at a reference point below the network layer and above the physical layer. The simplest definition is the number of bits per second that are physically delivered. A typical example where this definition is practiced is an Ethernet network. In this case, the maximum throughput is the gross bit rate or raw bit rate.
Some apps default to only download a preview or snippet of your emails until an email is opened. Make sure your app is set to download the full contents of your email for offline use. • Limitations for large folders - Folders containing upwards of 1 million or more emails will have issues downloading all the messages. To resolve this, move ...
Transmission rates are defined by rate of the bitstream of the digital signal and are designated by hyphenation of the acronym OC and an integer value of the multiple of the basic unit of rate, e.g., OC-48. The base unit is 51.84 Mbit/s. [2]
appending a special "END" byte to it, which distinguishes datagram boundaries in the byte stream, if the END byte occurs in the data to be sent, the two byte sequence ESC, ESC_END is sent instead, if the ESC byte occurs in the data, the two byte sequence ESC, ESC_ESC is sent. variants of the protocol may begin, as well as end, packets with END.