Search results
Results From The WOW.Com Content Network
This is a list of TCP and UDP port numbers used by protocols for operation of network applications. The Transmission Control Protocol (TCP) and the User Datagram Protocol (UDP) only need one port for bidirectional traffic. TCP usually uses port numbers that match the services of the corresponding UDP implementations, if they exist, and vice versa.
The figures below are simplex data rates, which may conflict with the duplex rates vendors sometimes use in promotional materials. Where two values are listed, the first value is the downstream rate and the second value is the upstream rate. The use of decimal prefixes is standard in data communications.
The loss of packet flow samples results in a slight reduction of the effective sampling rate. The UDP payload contains the sFlow datagram . Each datagram provides information about the sFlow version, the originating device’s IP address , a sequence number, the number of samples it contains and one or more flow and/or counter samples.
It is typically measured at a reference point below the network layer and above the physical layer. The simplest definition is the number of bits per second that are physically delivered. A typical example where this definition is practiced is an Ethernet network. In this case, the maximum throughput is the gross bit rate or raw bit rate.
G_Port (Generic Fabric port) Switch port that may function either as an E_Port, A_Port, or as an F_Port. [14] GL_Port (Generic Fabric Loop port) Switch port that may function either as an E_Port, A_Port, or as an Fx_Port. [14] PE_Port LCF within the Fabric that attaches to another PE_Port or to a B_Port through a link. [13]
appending a special "END" byte to it, which distinguishes datagram boundaries in the byte stream, if the END byte occurs in the data to be sent, the two byte sequence ESC, ESC_END is sent instead, if the ESC byte occurs in the data, the two byte sequence ESC, ESC_ESC is sent. variants of the protocol may begin, as well as end, packets with END.
The ABR service expects the end-system to adapt its traffic rate in accordance with the feedback so that it may obtain its fair share of available network resources. The goal of ABR service is to provide fast access to available network resources at up to the specified Peak Cell Rate (PCR).
The speed (or baud rate) includes bits for framing (stop bits, parity, etc.), thus the effective data rate is lower than the baud rate. For 8-N-1 encoding, only 80% of the bits are available for data (for every eight bits of data, ten bits are sent over the serial link — one start bit, the eight data bits, and the one stop bit).