Ads
related to: tire weight specs
Search results
Results From The WOW.Com Content Network
Prior to 1964, tires were all made to a 90% aspect ratio. Tire size was specified as the tire width in inches and the diameter in inches – for example, 6.50-15. [24] From 1965 to the early 1970s, tires were made to an 80% aspect ratio. Tire size was again specified by width in inches and diameter in inches.
Tire forces are divided into three axes: radial, lateral, and tangential (or fore-aft). The radial axis runs from the tire center toward the tread, and is the vertical axis running from the roadway through the tire center toward the vehicle. This axis supports the vehicle's weight. The lateral axis runs sideways across the tread.
Modern road tires have several measurements associated with their size as specified by tire codes like 225/70R14. The first number in the code (e.g., "225") represents the nominal tire width in millimeters. This is followed by the aspect ratio (e.g.,"70"), which is the height of the sidewall expressed as a percentage of the nominal tire width.
In 1958, Dunlop introduced its R5 racing tyre, replacing the cotton fabric of the earlier R1 to R4 tyres with nylon fabric, allowing for a reported 12 lb reduction in tyre weight. [3] During the 1960s, Dunlop introduced improved nylon casings, reduced aspect ratio, significantly increased tyre width, and the use of synthetic rubber. [3]
Suffix –A2 are new production with later model Cummins engine. The vehicles have a wide variety of configurations and weights. [4] [6] [7] Note that the motor and tire specifications, along with other improvements, apply to the A2 versions (and A1 versions) of each base model listed below. There is an M928, an M928A1, and M928A2.
The word tire is a short form of attire, from the idea that a wheel with a tire is a dressed wheel. [3] [4] Tyre is the oldest spelling, [5] and both tyre and tire were used during the 15th and 16th centuries. During the 17th and 18th centuries, tire became more common in print.