Ads
related to: deep pour epoxy cure time vs temperature
Search results
Results From The WOW.Com Content Network
Down investigated various room-temperature-cure epoxy resin adhesives suitable for use in glass conservation, testing their tendency to yellow. A fundamental molecular understanding of epoxy yellowing was achieved, when Krauklis and Echtermeyer discovered the mechanistic origin of yellowing in a commonly used amine epoxy resin, published in ...
J-B Weld (stylized as J-B WELD) is the name of their flagship product: a specialized, high-temperature epoxy adhesive for use in bonding materials together. The company has run advertisements showing engine block repair with J-B Weld. [2] The J-B Weld Company, founded in 1969 by Sam Bonham in Sulphur Springs, Texas, specializes in epoxy products.
The exposure time is a function of exposure dose and film thickness. After exposure the SU-8 needs to be baked again to complete the polymerization. This baking step is not as critical as the prebake but the rising of the temperature (again to 95 °C) needs to be slow and controlled. At this point the resist is ready to be developed.
The variation of G' and G" in time can indicate the extent of the curing reaction. [7] As shown in Figure 4, after an "induction time", G' and G" start to increase, with an abrupt change in slope. At a certain point they cross each other; afterwards, the rates of G' and G" decrease, and the moduli tend to a plateau.
Bonding at specific temperature, ambient pressure for specific amount of time; Post-bake/hard-cure to form solid BCB monomer layer; The wafers can be cleaned using H 2 O 2 + H 2 SO 4 or oxygen plasma. The cleaned wafers are rinsed with DI water and dried at elevated temperature, e.g. 100 to 200 °C for 120 min. [17]
RTV silicone rubbers are, however, generally expensive – especially platinum-cure. They are also sensitive to substances (sulfur-containing modelling clay such as Plastilina, for example) that may prevent the silicone from curing (referred to as cure inhibition). Silicones are usually very thick (high viscosity), and must be vacuum degassed ...