Search results
Results From The WOW.Com Content Network
In mechanical engineering, the thread angle of a screw is the included angle between the thread flanks, measured in a plane containing the thread axis. [1] This is a defining factor for the shape of a screw thread .
≡ 4π sr [16] – The solid angle subtended by a sphere at its centre. ≈ 12.566 37 sr: square degree: deg 2; sq.deg.; (°) 2: ≡ (π ⁄ 180) 2 sr: ≈ 0.304 62 × 10 −3 sr: steradian (SI unit) sr The solid angle subtended at the center of a sphere of radius r by a portion of the sphere having an area r 2. A sphere subtends 4π sr. [16 ...
The efficiency can be plotted versus the helix angle for a constant friction, as shown in the adjacent diagram. The maximum efficiency is a helix angle between 40 and 45 degrees, however a reasonable efficiency is achieved above 15°. Due to difficulties in forming the thread, helix angle greater than 30° are rarely used.
The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than 1 / 4 inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.
Lead angle is 90° to the helix angle between the helical tooth face and an equivalent spur tooth face. For the same lead, the lead angle is larger for smaller gear diameters. It is understood to be measured at the standard pitch diameter unless otherwise specified. A spur gear tooth has a lead angle of 90°, and a helix angle of 0°. See ...
Tent stitch is a small, diagonal needlepoint stitch that crosses over the intersection of one horizontal (weft) and one vertical (warp) thread of needlepoint canvas forming a slanted stitch at a 45-degree angle.
If this was just five years ago, let alone 10 or 20, the prospect of 72-year-old Bill Belichick as a college football coach would have been more about a splashy hire than the promise of great success.
JIC fittings, defined by the SAE J514 and MIL-DTL-18866 standards, are a type of flare fitting machined with a 37-degree flare seating surface. JIC (Joint Industry Council) fittings are widely used in fuel delivery and fluid power applications, especially where high pressure (up to 10,000 pounds per square inch (690 bar)) is involved.