Ads
related to: leaf spring shackle bushings autozone
Search results
Results From The WOW.Com Content Network
The front eye of each leaf spring is secured to the frame; the rear eye is attached by a shackle that pivots to allow the spring to lengthen as it flexes. The two ends of a leaf spring usually are formed into round eyes or eyelets, through which a fastener connects each end of the spring to the vehicle frame or body .
Leaf springs have been around since the early Egyptians. Ancient military engineers used leaf springs in the form of bows to power their siege engines, with little success at first. The use of leaf springs in catapults was later refined and made to work years later. Springs were not only made of metal; a sturdy tree branch could be used as a ...
A radius rod (also called a radius arm, torque arm, torque spring, and torsion bar) is a suspension link intended to control wheel motion in the longitudinal (fore-aft) direction. The link is connected (with a rubber or solid bushing ) on one end to the wheel carrier or axle , on the other to the chassis or unibody of the vehicle.
A multi-leaf spring consists of a series of flat plates, usually of semi-elliptical shape. The flat plates are called leaves of the spring. The leaf at the top has maximum length. The length gradually decreases from the top leaf to the bottom leaf. The longest leaf at the top is called master leaf. It is bent at both ends to form the spring eyes.
When considering where to put your money for retirement, you may have to choose between an IRA and an annuity.These financial “vehicles” are set up to ensure guaranteed income down the road ...
In many racing cars, the springs and dampers are relocated inside the bodywork. The suspension uses a bellcrank to transfer the forces at the knuckle end of the suspension to the internal spring and damper. This is then known as a "push rod" if bump travel "pushes" on the rod (and subsequently the rod must be joined to the bottom of the upright ...