Search results
Results From The WOW.Com Content Network
Peak-to-peak amplitude (abbreviated p–p or PtP or PtoP) is the change between peak (highest amplitude value) and trough (lowest amplitude value, which can be negative). With appropriate circuitry, peak-to-peak amplitudes of electric oscillations can be measured by meters or by viewing the waveform on an oscilloscope .
Amplitude modulation (AM) is a modulation technique used in electronic communication, most commonly for transmitting messages with a radio wave.In amplitude modulation, the amplitude (signal strength) of the wave is varied in proportion to that of the message signal, such as an audio signal.
The most common test signals that fulfill this are full amplitude triangle waves and sawtooth waves. For example, a 16-bit ADC has a maximum signal-to-quantization-noise ratio of 6.02 × 16 = 96.3 dB. When the input signal is a full-amplitude sine wave the distribution of the signal is no longer uniform, and the corresponding equation is instead
The term gain has a different meaning in antenna design; antenna gain is the ratio of radiation intensity from a directional antenna to / (mean radiation intensity from a lossless antenna). Graph of the input v i ( t ) {\displaystyle v_{i}(t)} (blue) and output voltage v o ( t ) {\displaystyle v_{o}(t)} (red) of an ideal linear amplifier with a ...
Amplitude (a) vs. frequency (f) graph illustrating baseband bandwidth. Here the bandwidth equals the upper frequency. Here the bandwidth equals the upper frequency. Bandwidth is the difference between the upper and lower frequencies in a continuous band of frequencies .
Different fields of application have different definitions for the term. All the meanings are very similar in concept: In chemistry, the transmission coefficient refers to a chemical reaction overcoming a potential barrier; in optics and telecommunications it is the amplitude of a wave transmitted through a medium or conductor to that of the incident wave; in quantum mechanics it is used to ...
A ratio higher than 1:1 (greater than 0 dB) indicates more signal than noise. SNR is an important parameter that affects the performance and quality of systems that process or transmit signals, such as communication systems, audio systems, radar systems, imaging systems, and data acquisition systems. A high SNR means that the signal is clear ...
The Q factor is a parameter that describes the resonance behavior of an underdamped harmonic oscillator (resonator). Sinusoidally driven resonators having higher Q factors resonate with greater amplitudes (at the resonant frequency) but have a smaller range of frequencies around that frequency for which they resonate; the range of frequencies for which the oscillator resonates is called the ...