Search results
Results From The WOW.Com Content Network
Diagram of thermodynamic surface from Maxwell's book Theory of Heat.The diagram is drawn roughly from the same angle as the upper left photo above, and shows the 3D axes e (energy, increasing downwards), ϕ (entropy, increasing to the lower right and out-of-plane), and v (volume, increasing to the upper right and into-plane).
The technique is closely related to using gas adsorption to measure pore sizes, but uses the Gibbs–Thomson equation rather than the Kelvin equation.They are both particular cases of the Gibbs Equations of Josiah Willard Gibbs: the Kelvin equation is the constant temperature case, and the Gibbs–Thomson equation is the constant pressure case. [1]
The Gibbs adsorption isotherm for multicomponent systems is an equation used to relate the changes in concentration of a component in contact with a surface with changes in the surface tension, which results in a corresponding change in surface energy. For a binary system, the Gibbs adsorption equation in terms of surface excess is
A century later Gibbs [3] proposed a modification to Young's equation to account for the volumetric dependence of the contact angle. Gibbs postulated the existence of a line tension, which acts at the three-phase boundary and accounts for the excess energy at the confluence of the solid-liquid-gas phase interface, and is given as:
The discontinuity in , and other properties, e.g. internal energy, , and entropy,, of the substance, is called a first order phase transition. [12] [13] In order to specify the unique experimentally observed pressure, (), at which it occurs another thermodynamic condition is required, for from Fig.1 it could clearly occur for any pressure in the range .
When perfectly pure, the interface between fluids usually displays only surface tension. [1] The stress within a fluid interface can be affected by the adsorption of surfactants in several ways: Change in the surface concentration of surfactants when the in-plane flow tends to alter the surface area of the interface (Gibbs' elasticity). [2]
The Marangoni effect (also called the Gibbs–Marangoni effect) is the mass transfer along an interface between two phases due to a gradient of the surface tension. In the case of temperature dependence, this phenomenon may be called thermo-capillary convection [ 1 ] or Bénard–Marangoni convection .
Surface tension is an important factor in the phenomenon of capillarity. Surface tension has the dimension of force per unit length, or of energy per unit area. [4] The two are equivalent, but when referring to energy per unit of area, it is common to use the term surface energy, which is a more general term in the sense that it applies also to ...