Ad
related to: transmission leaking from torque converter diagram
Search results
Results From The WOW.Com Content Network
This transmission, like single and dual range and dual coupling hydramatics, also has the feature of split torque in the transmission, whereby in fourth (or high) gear only 40% to 50% depending on transmission—40% in Roto's case—but because of the design the coupling is only required to carry 40% of the engine torque.
A torque converter is a device, usually implemented as a type of fluid coupling, that transfers rotating power from a prime mover, like an internal combustion engine, to a rotating driven load. In a vehicle with an automatic transmission, the torque
Beginning in 1998 a new 300mm torque converter with improved higher-capacity internals, 300mm style input shaft, and 300mm style pump was also introduced on models coupled to a Gen III Small Block. The 4L60E is rated to handle up to 360 ft⋅lb (490 N⋅m) of torque. It weighs 133 pounds without transmission fluid. [1]
For the 1981 model year, a lock-up torque converter was introduced which coincided with the new EMC control of most GM cars; this version is the THM350-C, which was phased out in 1984 in GM passenger cars for the 700R4. Chevrolet/GMC trucks and vans used the THM350-C until 1986. The lock-up torque converter was unpopular with transmission builders.
Hydramatic transmissions were ultimately replaced by a new three-speed torque converter automatic transmission called Turbo-Hydramatic in 1964 and 1965, whose design was more similar in principle to the Chrysler TorqueFlite and the '51 Borg-Warner-designed Ford Cruise-O-Matic than the fluid coupling Hydra-Matic the "Turbo" replaced.
When the torque converter technique was fully established, 3-speed units, the W3A 040 and W3B 050 (type 722.0) is combined with V8 engines, and it uses torque converter instead of fluid coupling. [ 1 ] [ 4 ] The transmission saves 1 planetary gearset and uses the same housing as the 4-speed versions.
Due to its two-speed with torque converter design, the Super Turbine 300 is often confused with Chevrolet's Powerglide — which was also a two-speed torque converter transmission, but the ST 300 had a different design from the Chevy unit, which had been around since 1950. The low band was the same as the 1955 up PG along with the same style ...
While the transmission is in gear, as engine speed increases, torque is transferred from the engine to the input shaft by the motion of the fluid, propelling the vehicle. In this regard, the behaviour of the fluid coupling strongly resembles that of a mechanical clutch driving a manual transmission .