Ads
related to: flexible metal strips with holes
Search results
Results From The WOW.Com Content Network
The metal frames may be formed of slotted angle - steel strips longitudinally pressed into a right-angle or L-shaped section (C- and box-section systems are also used where structures have to carry particularly heavy loads); these sections are perforated with circular holes or elongated slots to allow shelves to be mounted directly or fixed ...
Slotted angle (also sometimes referred to as slotted angle iron) is a system of reusable metal strips used to construct shelving, frames, work benches, equipment stands and other structures. The name derives, first, from the use of elongated slots punched into the metal at uniform intervals to enable assembly of structures fixed with nuts and ...
Image of flexible printed circuits prior to de-panelization. An Olympus Stylus camera without the case, showing the flex circuit assembly. Flexible electronics, also known as flex circuits, is a technology for assembling electronic circuits by mounting electronic components on flexible plastic substrates, such as polyimide, PEEK or transparent conductive polyester [1] film.
Isolation can be further improved by placing a metal wall on top of the via fence. These walls commonly form part of the device enclosure. The large holes in the via fences seen in figures 1 and 5 are screw holes for clamping these walls in place. The wall casting belonging to this circuit is shown in figure 3. [5] Figure 4. Via hole equivalent ...
Stripboard is the generic name for a widely used type of electronics prototyping material for circuit boards characterized by a pre-formed 0.1 inches (2.54 mm) regular (rectangular) grid of holes, with wide parallel strips of copper cladding running in one direction all the way along one side of an insulating bonded paper board.
A grommet is a ring or edge strip inserted into a hole through thin material, typically a sheet of textile fabric, sheet metal or composite of carbon fiber, wood or honeycomb. Grommets are generally flared or collared on each side to keep them in place, and are often made of metal, plastic, or rubber. They may be used to prevent tearing or ...
TO-99: Metal can package with eight radial leads; TO-100: Metal can package with ten radial leads, similar to TO-99; TO-126: Plastic-encapsulated package with three leads and a hole for mounting on a heat sink; TO-220: Through-hole plastic package with a (usually) metal heat sink tab and three leads; TO-226 [23]
A typical flyswatter. A flyswatter (or fly-swat, fly swatter [1]) usually consists of a small rectangular or round sheet of a lightweight, flexible, vented material (usually thin metallic, rubber, or plastic mesh) around 10 cm (4 in) across, attached to a handle about 30 to 60 cm (1 to 2 ft) long made of a lightweight material such as wire, wood, plastic, or metal.