Ad
related to: 3.5 inch floppy disk interface adapter for mac address change
Search results
Results From The WOW.Com Content Network
3.5-inch and 5.25-inch drives connect to the floppy controller using a 34-conductor flat ribbon cable for signal and control. Most controllers support two floppy drives, although the Shugart standard supports up to four drives attached to a single controller. A cable could have 5.25-inch style connectors, 3.5-inch style connectors, or a ...
It supported all of Apple's 3.5" floppy disk formats as well as all standard PC formats (e.g. MS-DOS, Windows), allowing the Macintosh to read and write all industry-standard floppy disk formats. The external drive was offered only briefly with support for the Apple II, coming late in that product's life.
Circuit components of the external USB SuperDisk for Macintosh. The drive itself is the same size as a standard 3.5″ floppy drive, but uses an ATA interface. On the right is the USB-to-ATA adapter, which plugs into an intermediate fan-out and power supply daughterboard that is inside the rear of the Mac drive's casing.
KryoFlux reads "flux transitions" from floppy disks at a very fine resolution. [6] It can also read disks originally written with different bit cell widths and drive speeds, with a normal fixed-speed drive. [7] The software is available for Microsoft Windows, [8] Mac OS and Linux. The KryoFlux controller plugs into a standard USB port, and ...
Internal SuperDrive floppy drive on a Macintosh LC II. The term was first used by Apple Computer in 1988 to refer to their 1.44 MB 3.5 inch floppy drive.This replaced the older 800 KB floppy drive that had been standard in the Macintosh up to then, but remained compatible [citation needed] in that it could continue to read and write both 800 KB (double-sided) and 400 KB (single-sided) floppy ...
8-inch floppy disk, inserted in drive, (3½-inch floppy diskette, in front, shown for scale) 3½-inch, high-density floppy diskettes with adhesive labels affixed The first commercial floppy disks, developed in the late 1960s, were 8 inches (203.2 mm) in diameter; [4] [5] they became commercially available in 1971 as a component of IBM products and both drives and disks were then sold ...
The upgrade consisted of a single chip swap (and a trivial motherboard modification), which Apple provided free only to persons who purchased a UniDisk 3.5 drive. A small sticker with an icon of a 3.5-inch floppy diskette was placed next to the existing 5.25-inch diskette icon above the floppy drive port indicating the machine had been upgraded.
When the controller and disk drive are assembled as one device, as it is the case with some external floppy disk drives, e.g., Commodore 1540 and USB floppy disk drives, [27] the internal floppy disk drive and its interface are unchanged, while the assembled device presents a different interface such as IEEE-488, parallel port or USB.