Search results
Results From The WOW.Com Content Network
The time constant is related to the RC circuit's cutoff frequency f c, by = = or, equivalently, = = where resistance in ohms and capacitance in farads yields the time constant in seconds or the cutoff frequency in hertz (Hz).
These equations show that a series RL circuit has a time constant, usually denoted τ = L / R being the time it takes the voltage across the component to either fall (across the inductor) or rise (across the resistor) to within 1 / e of its final value. That is, τ is the time it takes V L to reach V( 1 / e ) and V R to ...
These equations show that a series RC circuit has a time constant, usually denoted τ = RC being the time it takes the voltage across the component to either rise (across the capacitor) or fall (across the resistor) to within 1 / e of its final value. That is, τ is the time it takes V C to reach V(1 − 1 / e ) and V R to reach ...
The driven frequency may be called the undamped resonance frequency or undamped natural frequency and the peak frequency may be called the damped resonance frequency or the damped natural frequency. The reason for this terminology is that the driven resonance frequency in a series or parallel resonant circuit has the value. [1]
A parallel resonant circuit provides current magnification. A parallel resonant circuit can be used as load impedance in output circuits of RF amplifiers. Due to high impedance, the gain of amplifier is maximum at resonant frequency. Both parallel and series resonant circuits are used in induction heating.
This means that the time constant is the time elapsed after 63% of V max has been reached Setting for t = for the fall sets V(t) equal to 0.37V max, meaning that the time constant is the time elapsed after it has fallen to 37% of V max. The larger a time constant is, the slower the rise or fall of the potential of a neuron.
The y-axis is the ratio of the OCTC (open-circuit time constant) estimate to the true time constant. For the lowest pole use curve T_1; this curve refers to the corner frequency; and for the higher pole use curve T_2. The worst agreement is for τ 1 = τ 2. In this case τ ^ 1 = 2 τ 1 and the corner frequency is a factor of 2 too small. The ...
A second-order Butterworth filter (i.e., continuous-time filter with the flattest passband frequency response) has an underdamped Q = 1 / √ 2 . [ 11 ] A pendulum's Q-factor is: Q = Mω / Γ , where M is the mass of the bob, ω = 2 π / T is the pendulum's radian frequency of oscillation, and Γ is the frictional damping force on the ...