Search results
Results From The WOW.Com Content Network
When you enable VLAN interface creation, a switch creates a VLAN interface for the default VLAN (VLAN 1) to permit remote switch administration. SVIs are generally configured for a VLAN for the following reasons: Allow traffic to be routed between VLANs by providing a default gateway for the VLAN. Provide fallback bridging (if required for non ...
A VLAN access control list (VACL) provides access control for all packets that are bridged within a VLAN or that are routed into or out of a VLAN. Unlike regular Cisco IOS access control lists that are configured on router interfaces and applied on routed packets only, VACLs apply to all packets.
Many Internet hosting services use VLANs to separate customers' private zones from one other, allowing each customer's servers to be grouped in a single network segment no matter where the individual servers are located in the data center. Some precautions are needed to prevent traffic "escaping" from a given VLAN, an exploit known as VLAN hopping.
pfSense is a firewall/router computer software distribution based on FreeBSD. The open source pfSense Community Edition (CE) and pfSense Plus is installed on a physical computer or a virtual machine to make a dedicated firewall/router for a network. [ 3 ]
VLAN hopping is a computer security exploit, a method of attacking networked resources on a virtual LAN (VLAN). The basic concept behind all VLAN hopping attacks is for an attacking host on a VLAN to gain access to traffic on other VLANs that would normally not be accessible.
In other words, it is a type of a port that is allowed to send and receive frames from any other port on the VLAN. Host Ports: Isolated Port (I-Port): Connects to the regular host that resides on isolated VLAN. This port communicates only with P-Ports. Community Port (C-Port): Connects to the regular host that resides on community VLAN. This ...
Likewise XYZ uses IDs 11, 12 and 13 in their network, so X1 and X2 are also trunks with single tagged traffic of IDs 11, 12 and 13. The SP, having one network and one connection between S-Switch #1 and S-Switch #2, must segregate Acme's and XYZ's traffic. Since both Acme and XYZ share some VLAN IDs, traffic cannot be segregated by customer VLAN ID.
The thought being that traffic is denied if it fails the RPF check and is therefore filtered. While uRPF is used as an ingress filtering mechanism, it is affected by reverse-path forwarding . Reverse path filters are typically used to disable asymmetric routing where an IP application has a different incoming and outgoing routing path.