Search results
Results From The WOW.Com Content Network
The decibel (symbol: dB) is a relative unit of measurement equal to one tenth of a bel (B). It expresses the ratio of two values of a power or root-power quantity on a logarithmic scale. Two signals whose levels differ by one decibel have a power ratio of 10 1/10 (approximately 1.26) or root-power ratio of 10 1/20 (approximately 1.12). [1] [2]
Vinyl microgroove phonograph records typically yield 55-65 dB, though the first play of the higher-fidelity outer rings can achieve a dynamic range of 70 dB. [25] German magnetic tape in 1941 was reported to have had a dynamic range of 60 dB, [26] though modern-day restoration experts of such tapes note 45-50 dB as the observed dynamic range. [27]
On the other hand, frequency range is a term sometimes used of loudspeakers and other transducers to indicate the frequencies that are usable, without necessarily specifying a decibel range. Power bandwidth is also related to frequency response – indicating the range of frequencies usable at high power.
Each extra quantization bit increases the dynamic range by roughly 6 dB. Assuming a full-scale sine wave signal (that is, the quantizer is designed such that it has the same minimum and maximum values as the input signal), the quantization noise approximates a sawtooth wave with peak-to-peak amplitude of one quantization level [ 11 ] and ...
For very low-power systems, such as mobile phones, signal strength is usually expressed in dB-microvolts per metre (dBμV/m) or in decibels above a reference level of one milliwatt . In broadcasting terminology, 1 mV/m is 1000 μV/m or 60 dBμ (often written dBu).
dBc (decibels relative to the carrier) is the power ratio of a signal to a carrier signal, expressed in decibels.For example, phase noise is expressed in dBc/Hz at a given frequency offset from the carrier. dBc can also be used as a measurement of Spurious-Free Dynamic Range between the desired signal and unwanted spurious outputs resulting from the use of signal converters such as a digital ...
While describing sound in terms of sound pressure, a logarithmic conversion is usually applied and the sound pressure level is stated instead, in decibels (dB), with 0 dB SPL equal to 20 micropascals. A microphone is distinguishable by the voltage value produced when a known, constant root mean square sound pressure is applied. This is known as ...
A graph of the A-, B-, C- and D-weightings across the frequency range 10 Hz – 20 kHz Video illustrating A-weighting by analyzing a sine sweep (contains audio). A-weighting is a form of frequency weighting and the most commonly used of a family of curves defined in the International standard IEC 61672:2003 and various national standards relating to the measurement of sound pressure level. [1]