Search results
Results From The WOW.Com Content Network
EEC-III exploded view diagram. This system was used on certain 1980-83 vehicles. There were two different EEC-III modules; one for use with a feedback carburetor, and one for use with Ford's "Central" throttle-body fuel injection system. The module size and shape were approximately the same as the EEC-II and still utilized the external memory ...
The ECM is a type of electronic control unit (ECU), which is an embedded system that employs software to determine the required throttle position by calculations from data measured by other sensors, including the accelerator pedal position sensors, engine speed sensor, vehicle speed sensor, and cruise control switches.
The DDEC III ECM is thinner than the DDEC II ECM, with wiring connectors at both ends. The front-end has two five-pin connectors for the injectors, and a thirty-pin connector for the engine-sensors. The rear-end has a five-pin Power Connector, six-pin Communications Connector, and a thirty-pin Vehicle-Interface Harness-Connector.
An ECU from a Geo Storm. An electronic control unit (ECU), also known as an electronic control module (ECM), is an embedded system in automotive electronics that controls one or more of the electrical systems or subsystems in a car or other motor vehicle.
This interface was made in different varieties and changed with power train control modules (aka PCM, ECM, ECU). Different versions had slight differences in pin-outs and baud rates. Earlier versions used a 160 baud rate, while later versions went up to 8192 baud and used bi-directional communications to the PCM.
Flagstar is the name used by several businesses including: Flagstar Bank Flagstar Companies , a successor of Trans World Corporation, which ultimately changed its name to Denny's
The Ford Modular engine is an overhead camshaft (OHC) V8 and V10 gasoline-powered small block engine family introduced by Ford Motor Company in 1990 for the 1991 model year. . The term “modular” applied to the setup of tooling and casting stations in the Windsor and Romeo engine manufacturing plants, not the engine its
Common circuit diagram symbols (US ANSI symbols) An electronic symbol is a pictogram used to represent various electrical and electronic devices or functions, such as wires, batteries, resistors, and transistors, in a schematic diagram of an electrical or electronic circuit. These symbols are largely standardized internationally today, but may ...