Search results
Results From The WOW.Com Content Network
A limitation of Port Aggregation Protocol is that all the physical ports in the aggregation group must reside on the same switch. Cisco's 6500 and the 4500E platforms, remove this limitation using Virtual Switching System (VSS), [1] which allows port channels to be split between two chassis. PAgP is not supported in Cisco Nexus Switches.
[2] [3] [4] Regarding IP multicast, it is a technique for one-to-many communication over an IP network. IP multicast covers some part of common multicast routing protocol. IP multicast also describe IP multicast software (i.e. VideoLAN,qpimd – PIM Daemon for Quagga, GNU — PIM module for the Quagga Routing Suite, UFTP, etc.).
The Cisco Supervisor Engine serves as the management card for modular Cisco switches that can also, in some cases, act as forwarding/routing element. [1]Over time, the Supervisor Engine has undergone multiple iterations and was different for different modular switches in Cisco Portfolio (Catalyst 4000, 4500, 5000, 5500, 6000, 6500, 9400, 9600 and Nexus switches).
The multicast tree construction is receiver driven and is initiated by network nodes that are close to the receivers. IP multicast scales to a large receiver population. The IP multicast model has been described by Internet architect Dave Clark as, "You put packets in at one end, and the network conspires to deliver them to anyone who asks." [5]
GARP was used by two applications: GARP VLAN Registration Protocol (GVRP) for registering VLAN trunking between multilayer switches, and by the GARP Multicast Registration Protocol (GMRP). The latter two were both mostly enhancements for VLAN-aware switches per definition in IEEE 802.1Q .
In older Cisco IOS releases, PIM-DM would re-flood all the multicast traffic every 3 minutes. This is fine for low volume multicast, but not higher bandwidth multicast packet streams. More recent Cisco IOS versions support a new feature called PIM Dense Mode State Refresh, since 12.1(5)T.
Multicast is a network addressing method for the delivery of information to a group of destinations simultaneously using the most efficient strategy to deliver the messages over each link of the network only once, creating copies only when the links to the multiple destinations split (typically network switches and routers).
A multicast address is a logical identifier for a group of hosts in a computer network that are available to process datagrams or frames intended to be multicast for a designated network service. Multicast addressing can be used in the link layer (layer 2 in the OSI model ), such as Ethernet multicast, and at the internet layer (layer 3 for OSI ...