Search results
Results From The WOW.Com Content Network
A crank sensor (CKP) [1] [2] [3] is an electronic device used in an internal combustion engine, both petrol and diesel, to monitor the position or rotational speed of the crankshaft. This information is used by engine management systems to control the fuel injection or the ignition system timing and other engine parameters.
A crankcase is the housing in a piston engine that surrounds the crankshaft. In most modern engines, the crankcase is integrated into the engine block. Two-stroke engines typically use a crankcase-compression design, resulting in the fuel/air mixture passing through the crankcase before entering the cylinder(s). This design of the engine does ...
A properly designed crankcase breather will also be designed in a manner that promotes the scavenging effect, or the creation of suction within the crankcase breather to further aid in the removal of blow-by gases. It is this effect that keeps the crankcase at slightly negative pressure when a properly functioning PCV system is in place. [9]
On the other hand, the Honda VFR1200F engine has a 76° V angle and a 360° crankshaft with shared crank pins that have a 28° offset, resulting in 256°–104°–256°–104° firing interval. This engine also has an unusual connecting rod orientation of front–rear–rear–front, with a much wider distance between cylinders ('bore spacing ...
Crankshaft (red), pistons (gray), cylinders (blue) and flywheel (black) A crankshaft is a mechanical component used in a piston engine to convert the reciprocating motion into rotational motion. The crankshaft is a rotating shaft containing one or more crankpins, [1] that are driven by the pistons via the connecting rods. [2]
The cylinder heads are integrated into the engine block, but the crankcase is separate. [2] Typical 1930-1960 flathead engine with integrated crankcase. The cylinder head is tipped upwards for illustrative purposes. An engine where all the cylinders share a common block is called a monobloc engine. Most modern engines use a monobloc design, and ...
A harmonic balancer (sometimes called crankshaft damper, torsional damper, or vibration damper) is the same thing as a harmonic damper except that the balancer includes a counterweight to externally balance the rotating assembly. The harmonic balancer often serves as a pulley for the accessory drive belts turning the alternator, water pump and ...
The crankshaft configuration varies amongst opposed-engine designs. One layout has a flat/boxer engine at its center and adds an additional opposed-piston to each end so there are two pistons per cylinder on each side. An X engine is essentially two V engines joined by a common crankshaft. A majority of these were existing V-12 engines ...