When.com Web Search

  1. Ads

    related to: 15 16 wrench to mm

Search results

  1. Results From The WOW.Com Content Network
  2. Wrench size - Wikipedia

    en.wikipedia.org/wiki/Wrench_size

    Sizes that may interchange, depending on the precision needed, include 2 mm (close to 5 ⁄ 64 inch (1.98 mm)), 4 mm (close to 5 ⁄ 32 inch (3.97 mm)) and 8 mm (close to 5 ⁄ 16 inch (7.94 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.

  3. British Standard Whitworth - Wikipedia

    en.wikipedia.org/wiki/British_Standard_Whitworth

    BA threads have diameters of 6 mm (0BA) and smaller, and were and still are particularly used in precision machinery. The Whitworth 55° angle remains commonly used today worldwide in form of the 15 British standard pipe threads defined in ISO 7, which are commonly used in water supply, cooling, pneumatics, and hydraulic systems.

  4. Cone wrench - Wikipedia

    en.wikipedia.org/wiki/Cone_wrench

    Cone wrenches are typically about 2 mm thick, compared to approximately 7 mm for a standard open-ended wrench. ... 14, 15, 16 and 17mm. Most sizes 19mm and above are ...

  5. Metric drill bit sizes - Wikipedia

    en.wikipedia.org/wiki/Drill_bit_sizes

    From 1.0 through 2.95 mm, sizes are defined as follows, where N is an integer from 10 through 29: N · 0.1 mm; N · 0.1 + 0.05 mm; From 3.0 through 13.9 mm, sizes are defined as follows, where N is an integer from 30 through 139: N · 0.1 mm; From 14.0 through 25.0 mm, sizes are defined as follows, where M is an integer from 14 through 25: M ...

  6. Hex key - Wikipedia

    en.wikipedia.org/wiki/Hex_key

    A hex key (also, hex wrench, ... [15] Metric. Metric hex key set with sizes from 1.5 mm to 10 mm. ... [16] 0.7 mm, 0.9 mm, 1.3 mm ...

  7. List of drill and tap sizes - Wikipedia

    en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

    Schematic of a machine tap. Below is a comprehensive drill and tap size chart for all drills and taps, imperial and metric, up to 36.5 millimetres (1.44 in) in diameter.. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.