Ads
related to: dimmable bulb in regular socket definition in electronics
Search results
Results From The WOW.Com Content Network
In the case of the 50/100/150 W bulb, putting this bulb in a regular lamp socket will result in it behaving like a normal 100 W bulb. [citation needed] A key switch 3-way socket has the switch incorporated in the lamp socket and requires no external wiring between switch and socket. This would be typical in a 3-way floor-standing floor lamp.
This small device allowed the dimmer to be installed in a standard electrical wall box while saving energy. [2] [3] In 1966, Eugene Alessio patented a light bulb socket adapter for adjusting a light level on a single light bulb using a triac. To house this device, he decided on a 2-inch round device with one end capable of being screwed into a ...
Movable lamps have a plug and cord that plugs into a wall socket. Light fixtures may also have other features, such as reflectors for directing the light, an aperture (with or without a lens ), an outer shell or housing for lamp alignment and protection, an electrical ballast or power supply , and a shade to diffuse the light or direct it ...
An electric light, lamp, or light bulb is an electrical component that produces light.It is the most common form of artificial lighting.Lamps usually have a base made of ceramic, metal, glass, or plastic which secures the lamp in the socket of a light fixture, which is often called a "lamp" as well.
A dimmable ballast is very similar to a rapid start ballast, except that the autotransformer is connected to a dimmer. A quadrac type light dimmer can be used with a dimming ballast, which maintains the heating current while allowing lamp current to be controlled. A resistor of about 10 kΩ is required to be connected in parallel with the ...
The dimmer switch used in conjunction with a dimmable CFL must be matched to its power consumption range; [58] many dimmers installed for use with incandescent bulbs do not function acceptably below 40 W, whereas CFL applications commonly draw power in the range 7–20 W. Dimmable CFLs have been marketed before suitable dimmers are available.
These sockets included switches, but required bulbs to be mounted upright. The Edison organization developed a screw-base in 1880 which was initially made of wood but later made of plaster of Paris. [3] Many competitive designs of lamps and sockets appeared in the early era of incandescent lighting, which often were incompatible with other designs.
The suffix after the G indicates the pin spread; the G dates to the use of Glass for the original bulbs. GU usually also indicates that the lamp provides a mechanism for physical support by the luminaire: in some cases, each pin has a short section of larger diameter at the end (sometimes described as a "peg" rather than a "pin" [2]); the socket allows the bulb to lock into place by twisting ...