Search results
Results From The WOW.Com Content Network
In lay terms, the stoichiometric coefficient of any given component is the number of molecules and/or formula units that participate in the reaction as written. A related concept is the stoichiometric number (using IUPAC nomenclature), wherein the stoichiometric coefficient is multiplied by +1 for all products and by −1 for all reactants.
where A and B are reactants C is a product a, b, and c are stoichiometric coefficients,. the reaction rate is often found to have the form: = [] [] Here is the reaction rate constant that depends on temperature, and [A] and [B] are the molar concentrations of substances A and B in moles per unit volume of solution, assuming the reaction is taking place throughout the volume of the ...
A chemical equation is the symbolic representation of a chemical reaction in the form of symbols and chemical formulas.The reactant entities are given on the left-hand side and the product entities are on the right-hand side with a plus sign between the entities in both the reactants and the products, and an arrow that points towards the products to show the direction of the reaction. [1]
Consider the reaction A ⇌ 2 B + 3 C. Suppose an infinitesimal amount of the reactant A changes into B and C. This requires that all three mole numbers change according to the stoichiometry of the reaction, but they will not change by the same amounts.
However, complex (multi-step) reactions may or may not have reaction orders equal to their stoichiometric coefficients. This implies that the order and the rate equation of a given reaction cannot be reliably deduced from the stoichiometry and must be determined experimentally, since an unknown reaction mechanism could be either elementary or ...
Stoichiometry is used to run calculations about chemical reactions, for example, the stoichiometric mole ratio between reactants and products. The stoichiometry of a chemical reaction is based on chemical formulas and equations that provide the quantitative relation between the number of moles of various products and reactants, including yields ...
Conversion and its related terms yield and selectivity are important terms in chemical reaction engineering.They are described as ratios of how much of a reactant has reacted (X — conversion, normally between zero and one), how much of a desired product was formed (Y — yield, normally also between zero and one) and how much desired product was formed in ratio to the undesired product(s) (S ...
The equivalence point, or stoichiometric point, of a chemical reaction is the point at which chemically equivalent quantities of reactants have been mixed. For an acid-base reaction the equivalence point is where the moles of acid and the moles of base would neutralize each other according to the chemical reaction.