Search results
Results From The WOW.Com Content Network
A Voltage controller thyristor based dimmer rack An electrical schematic for a typical SCR-based light dimmer. A voltage controller, also called an AC voltage controller or AC regulator is an electronic module based on either thyristors, triodes for alternating current, silicon-controlled rectifiers or insulated-gate bipolar transistors, which converts a fixed voltage, fixed frequency ...
SCR 4-layer (p-n-p-n) diagram. A silicon controlled rectifier or semiconductor controlled rectifier is a four-layer solid-state current-controlling device.The name "silicon controlled rectifier" is General Electric's trade name for a type of thyristor.
A thyristor (/ θ aɪ ˈ r ɪ s t ər /, from a combination of Greek language θύρα, meaning "door" or "valve", and transistor [1]) is a solid-state semiconductor device which can be thought of as being a highly robust and switchable diode, allowing the passage of current in one direction but not the other, often under control of a gate electrode, that is used in high power applications ...
The current in the TCR is varied from maximum (determined by the connection voltage and the inductance of the reactor) to almost zero by varying the "Firing Delay Angle", α. α is defined as the delay angle from the point at which the voltage becomes positive to the point at which the thyristor valve is turned on and current starts to flow.
A gate turn-off thyristor (GTO) is a special type of thyristor, which is a high-power (e.g. 1200 V AC) semiconductor device. It was invented by General Electric . [ 1 ] GTOs, as opposed to normal thyristors, are fully controllable switches which can be turned on and off by their gate lead.
The wafer device is similar to a gate turn-off thyristor (GTO). They can be turned on and off by a gate signal, and withstand higher rates of voltage rise (dv/dt), such that no snubber is required for most applications. The structure of an IGCT is very similar to a GTO thyristor. In an IGCT, the gate turn-off current is greater than the anode ...
Transient voltage suppressors will fail if they are subjected to voltages or conditions beyond those that the particular product was designed to accommodate. There are three key modes in which the TVS will fail: short, open, and degraded device.
The following other wikis use this file: Usage on az.wikipedia.org Tiristor; Usage on be.wikipedia.org Тырыстар; Usage on bn.wikipedia.org