Search results
Results From The WOW.Com Content Network
The Serial Line Internet Protocol (SLIP) [1] [2] is an encapsulation of the Internet Protocol [a] designed to work over serial ports and router connections. It is documented in RFC 1055 . On personal computers, SLIP has largely been replaced by the Point-to-Point Protocol (PPP), which is better engineered, has more features, and does not ...
Modern high speed serial interfaces such as PCIe [2] [3] [4] send data several bits at a time using modulation/encoding techniques such as PAM4 which groups 2 bits at a time into a single symbol, and several symbols are still sent one at the time. This replaces PAM2 or non return to zero (NRZ) which only sends one bit at a time, or in other ...
Management Data Input/Output (MDIO), also known as Serial Management Interface (SMI) or Media Independent Interface Management (MIIM), is a serial bus defined for the Ethernet family of IEEE 802.3 standards for the Media Independent Interface, or MII. The MII connects media access control (MAC) devices with Ethernet physical layer (PHY ...
Most serial communications designs send the data bits within each byte least significant bit first. Also possible, but rarely used, is most significant bit first; this was used, for example, by the IBM 2741 printing terminal. The order of bits is not usually configurable within the serial port interface but is defined by the host system.
SPI protocol being a de facto standard, some SPI host adapters also have the ability of supporting other protocols beyond the traditional 4-wire SPI (for example, support of quad-SPI protocol or other custom serial protocol that derive from SPI [34]).
Modbus standard also defines Modbus over Serial Line, a protocol over the data link layer of the OSI model for the Modbus application layer protocol to be communicated over a serial bus. [19] Modbus Serial Line protocol is a master-slave protocol which supports one master and multiple slaves in the serial bus. [20]
For example, on the original IBM PC, a male D-sub was an RS-232-C DTE port (with a non-standard current loop interface on reserved pins), but the female D-sub connector on the same PC model was used for the parallel "Centronics" printer port. Some personal computers put non-standard voltages or signals on some pins of their serial ports.
Synchronous Data Link Control (SDLC) is a computer serial communications protocol first introduced by IBM as part of its Systems Network Architecture (SNA). SDLC is used as layer 2, the data link layer , in the SNA protocol stack .