Ads
related to: 1 inch by wood strips
Search results
Results From The WOW.Com Content Network
These are narrow strips of wood, extruded metal, or split boards, nailed horizontally across the wall studs or ceiling joists. Each wall frame is covered in lath, tacked at the studs. Wood lath is typically about one inch (2.5 cm) wide by four feet (1.2 m) long by 1 ⁄ 4 inch (6 mm) thick.
[1] The ties or sleepers were composed of narrow strips of 1-inch-thick (25 mm) board about 15 inches (380 mm) long, upon which were nailed (with small finish nails) rails made of soft wood, about 1 inch (25 mm) square and 10 inches (250 mm) apart. On these were nailed narrow strips of thin hoop iron, to complete the whole affair. [2]
Wood furring strips typically measure 1 x 2 or 1 x 3 inches. They can be laid out perpendicular to studs or joists and nailed to them, or set vertically against an existing wall surface. The spacing between the strips depends on the type of finishing material. Wider spacing is typically used behind the heavy boards that support ceramic tiles.
Roof laths span across between the rafters and support the wood shingles. A lath or slat is a thin, narrow strip of straight-grained wood used under roof shingles or tiles, on lath and plaster walls and ceilings to hold plaster, and in lattice and trellis work. [1] Lath has expanded to mean any type of backing material for plaster.
Laminated veneer lumber (LVL) – LVL comes in 1 + 3 ⁄ 4-inch (44 mm) thicknesses with depths such as 9 + 1 ⁄ 2, 11 + 7 ⁄ 8, 14, 16, 18 and 24 inches (240, 300, 360, 410, 460 and 610 mm), and are often doubled or tripled up. They function as beams to provide support over large spans, such as removed support walls and garage door openings ...
In flooring a batten may be relatively large, up to 2.5 inches (6.4 cm) thick by 7 inches (18 cm) wide and more than 6 feet (1.8 m) long. [4] Battens may also be used to secure carpet in place, where they are sometimes referred to as "gripper strips". [5] [6]