Search results
Results From The WOW.Com Content Network
The needle valve and carburettor are behind the cylinder where they are protected, and the crank case, cylinder and fuel tank are all machined from forgings, rather than weaker castings. The tank back plate/carburettor is a zinc alloy casting, or later a plastic casting, but crash stresses are already well distributed by the time they reach it.
An unusual form of four-stroke model engine that uses what is essentially a sleeve-valve format, is the British RCV series of "SP" model engines, which use a rotating cylinder liner driven through a bevel gear at the cylinder liner's "bottom", which is actually at the aft end of the cylinder; and, even more unusually, have the propeller shaft ...
Swirl flap principle in a four-valve engine. A swirl flap is a small butterfly valve fitted to four-stroke internal combustion engines with at least two intake valves.It is installed inside or just before one of a cylinder's two intake ports, allowing to throttle its intake port's air flow, causing a swirl in the other intake port not fitted with a swirl flap.
Cox Model Engines Cox Fokker DVII Ready To Fly Control Line Model Plane 1/2A model airplanes. Cox model engines are used to power small model airplanes, model cars and model boats. They were in production for more than 60 years between 1945 and 2006. The business is named for founder Leroy M. Cox.
Four-stroke model engines have been made in sizes as small as 0.20 in3 (3.3 cc) for the smallest single-cylinder models, all the way up to 3.05 in3 (50 cc) for the largest size for single-cylinder units, with twin- and multi-cylinder engines on the market being as small as 10 cc for opposed-cylinder twins, while going somewhat larger in size ...
A diverterless supersonic inlet (DSI) is a type of jet engine air intake used by some modern combat aircraft to control air flow into their engines. It consists of a "bump" and a forward-swept inlet cowl, which work together to divert boundary layer airflow away from the aircraft's engine.
A carbureted compression ignition model engine, popularly known as a model diesel engine, is a simple compression ignition engine made for model propulsion, usually model aircraft but also model boats. These are quite similar to the typical glow-plug engine that runs on a mixture of methanol-based fuels with a hot wire filament to provide ignition.
The JT15D was first run in 1967. Its use of a centrifugal compressor as the high-pressure stage in a turbofan engine was followed in 1970 by the Garrett TFE731. [1] The fan for the original JT15D-1 was aerodynamically scaled to 75 lb/sec using the much larger JT9D fan. [2] About 70% of the air passing through the fan goes down the bypass duct.