Ads
related to: common nail diameter
Search results
Results From The WOW.Com Content Network
Common: a common construction wire nail with a disk-shaped head that is typically 3 to 4 times the diameter of the shank: common nails have larger shanks than box nails of the same size; Cut: machine-made square nails. Now used for masonry and historical reproduction or restoration
A larger number indicates a longer nail, shown in the table below. Diameter of the nail also varies based on penny size, depending on nail type. Nails under 1 + 1 ⁄ 4 inch, often called brads, are sold mostly in small packages with only a length designation or with length and wire gauge designations; for example, 1″ 18 ga. or 3 ⁄ 4 ″ 16 ga.
The nail was apparently named after the practice of hammering brass nails into the counter at shops where cloth was sold. [2] [3] [4] On the other hand, R D Connor, in The weights and measures of England (p 84) states that the nail was the 16th part of a Roman foot, i.e., digitus or finger, although he provides no reference to support this. [5]
The largest sizes of conventional collated fastenings are the clipped head and full head nails which are used in framing, fencing and other forms of structural and exterior work. These nails generally have a shank diameter of 0.11 to 0.13 in (2.8 to 3.3 mm) although some manufacturers offer smaller diameter nails as well.
For sizes 1 ⁄ 4 inch and larger the size is given as a fraction; for sizes less than this an integer is used, ranging from 0 to 16. The integer sizes can be converted to the actual diameter by using the formula 0.060 + (0.013 × number). For example, a #4 screw is 0.060 + (0.013 × 4) = 0.060 + 0.052 = 0.112 inches in diameter.
A transfer punch is a punch (usually in an index set) of a specific outer diameter that is non-tapered and extends the entire length of the punch (except for the tip). It is used to tightly fit the tolerances of an existing hole and, when struck, precisely transfer the center of that hole to another surface.