Search results
Results From The WOW.Com Content Network
In architecture, the capital (from Latin caput 'head') or chapiter forms the topmost member of a column (or a pilaster). It mediates between the column and the load thrusting down upon it, broadening the area of the column's supporting surface.
The shaft of the Doric order is channeled with 20 flutes. The capital consists of a necking or annulet, which is a simple ring. The echinus is convex, or circular cushion like stone, and the abacus is a square slab of stone. Above the capital is a square abacus connecting the capital to the entablature.
The Ionic anta capital, in contrast to the regular column capitals, is highly decorated and generally includes bands of alternating lotuses and flame palmettes, and bands of eggs and darts and beads and reels patterns, in order to maintain continuity with the decorative frieze lining the top of the walls. This difference with the column ...
In Australia, these steel sections are commonly referred to as Universal Beams (UB) or Columns (UC). The designation for each is given as the approximate height of the beam, the type (beam or column) and then the unit metre rate (e.g., a 460UB67.1 is an approximately 460 mm (18.1 in) deep universal beam that weighs 67.1 kg/m (135 lb/yd)). [6]
Spiral columns are cylindrical columns with a continuous helical bar wrapping around the column. The spiral acts to provide support in the transverse direction and prevent the column from barreling. The amount of reinforcement is required to provide additional load-carrying capacity greater than or equal to that attributed from the shell as to ...
A steel column is extended by welding or bolting splice plates on the flanges and webs or walls of the columns to provide a few inches or feet of load transfer from the upper to the lower column section. A timber column is usually extended by the use of a steel tube or wrapped-around sheet-metal plate bolted onto the two connecting timber sections.
Following Serlio's interpretation of Vitruvius (who gives no indication of the column's capital), in the Tuscan order the column had a simpler base—circular rather than squared as in the other orders, where Vitruvius was being followed—and with a simple torus and collar, and the column was unfluted, while both capital and entablature were ...
The abacus upon the capital has concave sides to conform to the outscrolling corners of the capital, and it may have a rosette at the center of each side. Corinthian columns were erected on the top level of the Roman Colosseum, holding up the least weight, and also having the slenderest ratio of thickness to height. Their height to width ratio ...