Search results
Results From The WOW.Com Content Network
Log 10 of methanol vapor pressure vs. temperature. Uses Antoine's equation: ...
The pressure on a pressure-temperature diagram (such as the water phase diagram shown above) is the partial pressure of the substance in question. A phase diagram in physical chemistry , engineering , mineralogy , and materials science is a type of chart used to show conditions (pressure, temperature, etc.) at which thermodynamically distinct ...
On the left-hand vertical axis, locate and mark the point containing the pressure 100 psia. On the right-hand vertical axis, locate and mark the point containing the temperature 60°F. Connect the points with a straight line. Note where the line crosses the methane axis. Read this K-value off the chart (approximately 21.3).
Values are given in terms of temperature necessary to reach the specified pressure. Valid results within the quoted ranges from most equations are included in the table for comparison. A conversion factor is included into the original first coefficients of the equations to provide the pressure in pascals (CR2: 5.006, SMI: -0.875).
This Wikipedia page provides a comprehensive list of boiling and freezing points for various solvents.
In a binary boiling-point diagram, temperature (T ) (or sometimes pressure) is graphed vs. x 1. At any given temperature (or pressure) where both phases are present, vapor with a certain mole fraction is in equilibrium with liquid with a certain mole fraction. The two mole fractions often differ.
A Assuming an altitude of 194 metres above mean sea level (the worldwide median altitude of human habitation), an indoor temperature of 23 °C, a dewpoint of 9 °C (40.85% relative humidity), and 760 mmHg sea level–corrected barometric pressure (molar water vapor content = 1.16%). B Calculated values *Derived data by calculation.
Mole fraction vs. temperature diagram for a two-component system, showing the bubble point and dew point curves. In thermodynamics, the bubble point is the temperature (at a given pressure) where the first bubble of vapor is formed when heating a liquid consisting of two or more components.