Ad
related to: convert percent slope to ft/ft and area equation
Search results
Results From The WOW.Com Content Network
This means that for every 4 units (feet or metres) of horizontal distance there is a 1 unit (foot or metre) vertical change either up or down." [3] Any of these may be used. Grade is usually expressed as a percentage - converted to the angle α by taking the inverse tangent of the standard mathematical slope, which is rise / run or the grade ...
The equation for head loss in pipes, also referred to as slope, S, expressed in "feet per foot of length" vs. in 'psi per foot of length' as described above, with the inside pipe diameter, d, being entered in feet vs. inches, and the flow rate, Q, being entered in cubic feet per second, cfs, vs. gallons per minute, gpm, appears very similar.
Stream gradient (or stream slope) is the grade (or slope) of a stream. It is measured by the ratio of drop in elevation and horizontal distance. [ 1 ] It is a dimensionless quantity , usually expressed in units of meters per kilometer (m/km) or feet per mile (ft/mi); it may also be expressed in percent (%).
The alttype field allows conversion between units of different type, provided each unit is whitelisted to allow the conversion. As at December 2013, the following energy units have alttype = "torque" (the first line consists of different units, while the second line consists of aliases for units in the first line):
Allen Hazen derived an empirical formula for approximating hydraulic conductivity from grain-size analyses: = where Hazen's empirical coefficient, which takes a value between 0.0 and 1.5 (depending on literature), with an average value of 1.0. A.F. Salarashayeri & M. Siosemarde indicate C is usually between 1.0 and 1.5, with D in mm and K in cm/s.
The only conversion necessary then is to take / here and equate it to above. Also, this formula is the tape sag correction to be added to the measured distance, so the negative sign in front can be removed and the tape sag correction can be made instead by subtracting the absolute value as is done in the preceding section.
k is a conversion factor between SI and English units. It can be left off, as long as you make sure to note and correct the units in the n term. If you leave n in the traditional SI units, k is just the dimensional analysis to convert to English. k = 1 for SI units, and k = 1.49 for English units. (Note: (1 m) 1/3 /s = (3.2808399 ft) 1/3 /s = 1 ...
Cross slope is the angle around a vertical axis between: the horizontal line that is perpendicular to the road's center line, and; the surface. Typical values range from 2 percent for straight segments to 10 percent for sharp superelevated curves.