Search results
Results From The WOW.Com Content Network
An effluent sewer that uses gravity may be called a septic tank effluent gravity (STEG) system, while a pumping system may be called a septic tank effluent pumping (STEP) system. It is also possible to have a hybrid system that uses gravity and pumping. Gravity and pumping effluent sewer systems both have advantages and disadvantages.
The aeration stage and the disinfecting stage are the primary differences from a traditional septic system; in fact, an aerobic treatment system can be used as a secondary treatment for septic tank effluent. [1] These stages increase the initial cost of the aerobic system, and also the maintenance requirements over the passive septic system.
Septic tank additives have been promoted by some manufacturers with the aim to improve the effluent quality from septic tanks, reduce sludge build-up and to reduce odors. These additives—which are commonly based on "effective microorganisms"—are usually costly in the longer term and fail to live up to expectations. [14]
KOS+ M openwell submersible pump. Small-scale sewage pumping is normally done by a submersible pump.. This became popular in the early 1960s, when a guide rail system was developed to lift the submersible pump out of the pump station for repair, and ended the dirty and sometimes dangerous task of sending people into the sewage or wet pit. [1]
It thus converts it into an effluent that can be returned to the water cycle. Once back in the water cycle, the effluent creates an acceptable impact on the environment. It is also possible to reuse it. This process is called water reclamation. [1] The treatment process takes place in a wastewater treatment plant.
Sewage treatment (or domestic wastewater treatment, municipal wastewater treatment) is a type of wastewater treatment which aims to remove contaminants from sewage to produce an effluent that is suitable to discharge to the surrounding environment or an intended reuse application, thereby preventing water pollution from raw sewage discharges. [2]
The rotating packs of disks (known as the media) are contained in a tank or trough and rotate at between 2 and 5 revolutions per minute. Commonly used plastics for the media are polyethylene, PVC and expanded polystyrene. The shaft is aligned with the flow of wastewater so that the discs rotate at right angles to the flow, with several packs ...
The relatively grease-free water is then fed into the normal septic system.The food solids at the bottom and floating oil and grease must be periodically removed in a manner similar to septic tank pumping. [11] A traditional grease trap is not a food disposal unit. Unfinished food must be scraped into the garbage or food recycling bin.