Ad
related to: sata express vs 3 speed test
Search results
Results From The WOW.Com Content Network
The Serial ATA interface was designed primarily for interfacing with hard disk drives (HDDs), doubling its native speed with each major revision: maximum SATA transfer speeds went from 1.5 Gbit/s in SATA 1.0 (standardized in 2003), through 3 Gbit/s in SATA 2.0 (standardized in 2004), to 6 Gbit/s as provided by SATA 3.0 (standardized in 2009). [9]
The physical phenomena on which the device relies (such as spinning platters in a hard drive) will also impose limits; for instance, no spinning platter shipping in 2009 saturates SATA revision 2.0 (3 Gbit/s), so moving from this 3 Gbit/s interface to USB 3.0 at 4.8 Gbit/s for one spinning drive will result in no increase in realized transfer rate.
UFS 3.0 SATA-300 SATA-600 PCIe 2.0 x1 PCIe 2.0 x2 PCIe 3.0 x2 PCIe 3.0 x8 Speed (full-duplex) 104 MB/s 156 MB/s 624 MB/s ... PCI Express Mini Card: EM mSATA: XM PC ...
A 3.5-inch Serial ATA hard disk drive A 2.5-inch Serial ATA solid-state drive. SATA was announced in 2000 [4] [5] in order to provide several advantages over the earlier PATA interface such as reduced cable size and cost (seven conductors instead of 40 or 80), native hot swapping, faster data transfer through higher signaling rates, and more efficient transfer through an (optional) I/O queuing ...
SAS allows a higher transfer speed (SAS-1, SAS-2, SAS-3, and SAS-4 supports data bandwidth of 3, 6, 12, and 24 Gbits/sec, respectively) [10] than most parallel SCSI standards. SAS achieves these speeds on each initiator-target connection, hence getting higher throughput, whereas parallel SCSI shares the speed across the entire multidrop bus.
The SAS is a new generation serial communication protocol for devices designed to allow for much higher speed data transfers and is compatible with SATA. SAS uses a mechanically identical data and power connector to standard 3.5-inch SATA1/SATA2 HDDs, and many server-oriented SAS RAID controllers are also capable of addressing SATA hard drives.
The first HDD [11] had an average seek time of about 600 ms. [12] and by the middle 1970s, HDDs were available with seek times of about 25 ms. [13]Some early PC drives used a stepper motor to move the heads, and as a result had seek times as slow as 80–120 ms, but this was quickly improved by voice coil type actuation in the 1980s, reducing seek times to around 20 ms.
SATA Express allows the use of two PCI Express 2.0 or 3.0 lanes and two SATA 3.0 (6 Gbit/s) ports through the same host-side SATA Express connector (but not both at the same time). SATA Express supports NVMe as the logical device interface for attached PCI Express storage devices.