Search results
Results From The WOW.Com Content Network
The shell method goes as follows: Consider a volume in three dimensions obtained by rotating a cross-section in the xy-plane around the y-axis. Suppose the cross-section is defined by the graph of the positive function f(x) on the interval [a, b]. Then the formula for the volume will be:
For example, if the tool fails at 1,500 ft (460 m) while drilling with a triple rig (able to trip 3 joints of pipe, or about 90 ft (30 m) feet, at a time), then it would generally be faster to pull the tool out of the hole than it would be to rig up wireline and retrieve the tool, especially if the wireline unit must be transported to the rig.
Shell's in situ conversion process has been under development since the early 1980s. [1] In 1997, the first small scale test was conducted on the 30-by-40-foot (9.1 by 12.2 m) Mahogany property test site, located 200 miles (320 km) west of Denver on Colorado's Western Slope in the Piceance Creek Basin.
This is the volume contained between the inside diameter of the hole and the outside diameter of the pipe. Annular capacity is given by : Annular capacity (bbl/ft) = (ID hole 2 - OD pipe 2) / 1029.4. where ID hole 2 = Inside diameter of the casing or open hole in inches OD pipe 2 = Outside diameter of the pipe in inches. Similarly
Shell balances can be used in many situations. For example, flow in a pipe, the flow of multiple fluids around each other, or flow due to pressure difference. Although terms in the shell balance and boundary conditions will change, the basic set up and process is the same.
A borehole is a narrow shaft bored in the ground, either vertically or horizontally. A borehole may be constructed for many different purposes, including the extraction of water (drilled water well and tube well), other liquids (such as petroleum), or gases (such as natural gas).
Directional boring machine. Directional boring, also referred to as horizontal directional drilling (HDD), is a minimal impact trenchless method of installing underground utilities such as pipe, conduit, or cables in a relatively shallow arc or radius along a prescribed underground path using a surface-launched drilling rig.
Different methods of measuring the drill pipe length also have a significant effect on the accuracy of the measurement made. Pipe "strapping" is commonly used to define drill pipe length, where the pipe is measured on the pipe racks using a (steel) measure tape. These results are noted in a tally book, and the drillstring length is hence defined.