Search results
Results From The WOW.Com Content Network
A single compression seal fitting may seal on a single or multiple elements. Sealing glands designed to seal on single elements consist of a body, cap, sealant and follower. When sealing on multiple elements, gland designs also include a seat and an anti-rotation pin to prevent wires or conductors from twisting and shearing.
A gland is a general type of stuffing box, used to seal a rotating or reciprocating shaft against a fluid. The most common example is in the head of a tap where the gland is usually packed with string which has been soaked in tallow or similar grease.
The design of the seal ring must allow for minimizing distortion and maximizing heat transfer while considering the secondary sealing element, drive mechanism, spring and ease of assembly. Many seal rings contain the seal face diameters, although this is not a requirement of the primary ring. The seal ring always contains the balance diameter.
Split seals [4] are innovative sealing solutions designed to enhance efficiency and convenience in various mechanical systems. These seals are specifically engineered to address the challenges associated with traditional seals, offering improved installation, maintenance, and operational benefits. Bung; Compression seal fitting; Diaphragm seal
Shrouded cable glands going into a flow meter. Split cable gland KVT for routing pre-terminated cables. A cable gland (more often known in the U.S. as a cord grip, cable strain relief, cable connector or cable fitting) is a device designed to attach and secure the end of an electrical cable to the equipment. [1]
Glenn L. Martin Company was founded by aviation pioneer Glenn Luther Martin on August 16, 1912. [3] He started the company building military training aircraft in Santa Ana, California , and in September 1916, Martin accepted a merger offer from the Wright Company , creating the Wright-Martin Aircraft Company. [ 1 ]
Category 2 seal are intended for API-610 This category is applicable for temperatures between –40 °F and 750 °F (-40 °C and 400 °C) and pressures to 615 PSI (42 bar). Category 3 seals are essentially the original seals of 1st Edition and are also intended for API-610 pumps. Category 3 seals are intended for the most demanding applications.
The Martin Marietta Corporation was an American company founded in 1961 through the merger of Glenn L. Martin Company and American-Marietta Corporation. In 1995, it merged with Lockheed Corporation to form Lockheed Martin .