Search results
Results From The WOW.Com Content Network
Identification between the two can be made by examining the hub: the protrusion of the hub through the center of the wheel denotes the preferred 10.5-inch full-floating rear axle. While the 9.5-inch rear end exhibits its own durability, it is generally considered less favorable for high-torque applications.
The Dana/Spicer Model 35 is an automotive axle.It has been manufactured by Dana Holding Corporation since 1985 when American Motors (AMC) sold its axle tooling equipment to Dana. [1]
Ring gear diameter: 9 3 ⁄ 4 " Axle shaft diameter 1.41” Front (32 spline) 1.46” Rear (32 spline) 1.50” Front (35 spline) 1.50” Rear (35 spline) Inner axle shaft splines: 16, 23, 30, 32, 33 or 35 Aftermarket inner axle shaft splines: 40 for after market, high performance axles, equivalent to Dana 70 components; Pinion shaft diameter: 1 ...
Starter ring gear attached to a flywheel. In cars with a manual transmission, the starter ring gear is fitted to the outer diameter of the flywheel.The ring gear is usually fixed to the flywheel through use of an interference fit, [2] which is achieved by heating the ring gear and so that thermal expansion allows it to be placed around the flywheel.
Illustration of a ring-and-pinion differential for a rear-wheel drive vehicle Schematic diagram of a ring-and pinion differential. A relatively simple design of differential is used in rear-wheel drive vehicles, whereby a ring gear is driven by a pinion gear connected to the transmission.
The first version was produced from 1985 to 1992. The second version, produced from 1993 to 1997 featured a stronger pinion/yoke. This corrected a known, but rare, issue of the pinion yoke nut working loose. The first and second versions of the 10.25 axle are colloquially known as “short pinion-yoke” and “long pinion-yoke” respectively.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
The Diametral Pitch (DP) is the number of teeth per inch of diameter of the pitch circle. The units of DP are inverse inches (1/in). [3] DP = Diametral Pitch PD = Pitch Circle Diameter in inches CP = Circular Pitch in inches n = Number of Teeth DP = n / PD The Diametral Pitch (DP) is equal to π divided by the Circular Pitch (CP). DP = 3.1416 / CP