Ads
related to: ring and pinion pattern chart
Search results
Results From The WOW.Com Content Network
The pinion is supported both in front of and behind the pinion teeth, [7] an arrangement often referred to as "straddle mounting." Straddle mounting greatly reduces pinion deflection under high torque loads, conferring increased longevity and torque capacity. The pinion is also removable from the back as well, making for easier access.
Ring, pinion and carrier all remained between the solid axle and independent rear suspension. The solid rear axle from 1995-2001 Explorers is a popular swap for older Jeep Wranglers and Cherokees. In addition to being nearly the same width, they have the same wheel bolt pattern, are equipped with disc brakes, and are much stronger than the Dana ...
AMC 20s have an 8 7/8" ring gear and use a 29 spline axle shaft. The AMC 20 was most often used with V8 engines in cars and Jeeps . It was also used in the AM General Humvee .
Illustration of a ring-and-pinion differential for a rear-wheel drive vehicle Schematic diagram of a ring-and pinion differential. A relatively simple design of differential is used in rear-wheel drive vehicles, whereby a ring gear is driven by a pinion gear connected to the transmission.
The first version was produced from 1985 to 1992. The second version, produced from 1993 to 1997 featured a stronger pinion/yoke. This corrected a known, but rare, issue of the pinion yoke nut working loose. The first and second versions of the 10.25 axle are colloquially known as “short pinion-yoke” and “long pinion-yoke” respectively.
The Dana/Spicer Model 70 is an automotive axle manufactured by Dana Holding Corporation and has been used in OEM heavy duty applications by Chevrolet, Dodge, and Ford.It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "70" cast in to the housing, which is visually similar to the Dana 60.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
The Dana/Spicer Model 80 is an automotive axle manufactured by Dana Holding Corporation and has been used in OEM heavy duty applications by Chevrolet, Dodge, and Ford.It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "80" cast into the housing.