Ad
related to: ring and pinion pattern
Search results
Results From The WOW.Com Content Network
Larger ring and pinion versus the "14-bolt" axle, although the pinion lacks support bearings similar to the 14-bolt design. Selectable locking differential available on the 2014–present Ram Power Wagon. 11.8 AAM axle, optioned on Ram 3500 trucks with the High Output package
Ring, pinion and carrier all remained between the solid axle and independent rear suspension. The solid rear axle from 1995-2001 Explorers is a popular swap for older Jeep Wranglers and Cherokees. In addition to being nearly the same width, they have the same wheel bolt pattern, are equipped with disc brakes, and are much stronger than the Dana ...
AMC 20s have an 8 7/8" ring gear and use a 29 spline axle shaft. The AMC 20 was most often used with V8 engines in cars and Jeeps . It was also used in the AM General Humvee .
The first version was produced from 1985 to 1992. The second version, produced from 1993 to 1997 featured a stronger pinion/yoke. This corrected a known, but rare, issue of the pinion yoke nut working loose. The first and second versions of the 10.25 axle are colloquially known as “short pinion-yoke” and “long pinion-yoke” respectively.
The Dana/Spicer Model 70 is an automotive axle manufactured by Dana Holding Corporation and has been used in OEM heavy duty applications by Chevrolet, Dodge, and Ford.It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "70" cast in to the housing, which is visually similar to the Dana 60.
Throughout the 1990s Ford used the Dana 35 as a front axle in both TTB and IFS variations. These units follow Ford's tradition of using high pinion, reverse cut units. Dodge used this front axle for a few years in Dakotas and Durangos. GAWR up to 2900 lbs depending on variation and set up.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
This ring and pinion is significantly stronger with a better pinion to ring gear tooth contact patch and angle. It was typically used in the back of jeep JKs, Isuzus and Nissan pickups. This ring and pinion does share some components and can be adapted into an earlier Dana 44 but requires some work, different bearings and spacers.