Ad
related to: ipv4 subnetting tutorial
Search results
Results From The WOW.Com Content Network
A subnet mask is a bitmask that encodes the prefix length associated with an IPv4 address or network in quad-dotted notation: 32 bits, starting with a number of 1-bits equal to the prefix length, ending with 0-bits, and encoded in four-part dotted-decimal format: 255.255.255.0. A subnet mask encodes the same information as a prefix length but ...
Creating a subnet by dividing the host identifier. A subnetwork, or subnet, is a logical subdivision of an IP network. [1]: 1, 16 The practice of dividing a network into two or more networks is called subnetting. Computers that belong to the same subnet are addressed with an identical group of its most-significant bits of their IP addresses.
Mapping of Address and Port is a Cisco proposal that combines Address plus Port translation with tunneling of the IPv4 packets over an ISP provider's internal IPv6 network. In effect, it is an (almost) stateless alternative to carrier-grade NAT and DS-Lite that pushes the IPv4 address /port translation function (and the maintenance of NAT state ...
The original list of IPv4 address blocks was published in September 1981. [3] In previous versions of the document, [19] [20] network numbers were 8-bit numbers rather than the 32-bit numbers used in IPv4. At that time, three networks were added that were not listed earlier: 42.rrr.rrr.rrr, 43.rrr.rrr.rrr, and 44.rrr.rrr.rrr.
Open Shortest Path First (OSPF) is encapsulated in IP, but runs only on the IPv4 subnet, while the IPv6 version runs on the link using only link-local addressing. IGRP, and EIGRP are directly encapsulated in IP. EIGRP uses its own reliable transmission mechanism, while IGRP assumed an unreliable transport.
If there are multiple routes with the same subnet mask, the route with the lowest metric is used. If there are multiple default routes, the metric is also used to determine which to use. If there are multiple routes with the same subnet mask and metric, the system may use equal-cost multi-path routing as a forwarding strategy.
Internet Protocol version 4 (IPv4) is the first version of the Internet Protocol (IP) as a standalone specification. ... For example, in the subnet 192.168.5.0 / 24 ...
Interior Gateway Routing Protocol, Exterior Gateway Protocol and version 1 of the Routing Information Protocol (RIPv1) assume classful addressing, and therefore cannot transmit the subnet mask information required for supernetting. Enhanced Interior Gateway Routing Protocol (EIGRP) supports CIDR. By default, EIGRP summarizes the routes within ...