When.com Web Search

  1. Ads

    related to: connect 2 antennas together splitter

Search results

  1. Results From The WOW.Com Content Network
  2. Power dividers and directional couplers - Wikipedia

    en.wikipedia.org/wiki/Power_dividers_and...

    However using port 2 or port 4 as the input results in a 180° hybrid. [30] This fact leads to another useful application of the hybrid ring: it can be used to produce sum (Σ) and difference (Δ) signals from two input signals as shown in figure 12. With inputs to ports 2 and 3, the Σ signal appears at port 1 and the Δ signal appears at port ...

  3. Diplexer - Wikipedia

    en.wikipedia.org/wiki/Diplexer

    That cable would then run from the roof into the house. At a convenient point, a second diplexer would split the two signals apart; one signal would go to the TV set and the other to the IRD of the DBS set-top box. These usually have an antenna input and a diplexer, so that the antenna signal is also distributed along with the satellite.

  4. Duplexer - Wikipedia

    en.wikipedia.org/wiki/Duplexer

    When the transmitter is active, the resulting high voltage causes the tube to conduct, shorting together the receiver terminals to protect it, while its complementary, the anti-transmit/receive (ATR) switch, is a similar discharge tube which decouples the transmitter from the antenna while not operating, to prevent it from wasting received energy.

  5. Musa connector - Wikipedia

    en.wikipedia.org/wiki/Musa_connector

    "Multiple Unit Steerable Antenna" refers to an array of rhombic antennas used for high frequency (3–30 MHz) trans-Atlantic communication, "steerable" by the act of connecting several antennas together via a phasing circuit, thus achieving maximum antenna gain in the required direction. [2]

  6. Wilkinson power divider - Wikipedia

    en.wikipedia.org/wiki/Wilkinson_power_divider

    No loss occurs when the signals at ports 2 and 3 are in phase and have equal magnitude. In case of noise input to ports 2 and 3, the noise level at port 1 does not increase, half of the noise power is dissipated in the resistor. By cascading, the input power might be divided to any -number of outputs.

  7. Orthomode transducer - Wikipedia

    en.wikipedia.org/wiki/Orthomode_transducer

    The transmission signal of the up-link, of relatively high power (1, 2, or 5 watts for common VSAT equipment) originating from BUC and the very low power received signal power (in the order of μV) coming from the antenna to the LNB receiver unit, in this case are at an angle of 90° relative to each other, are both coupled together at the feed ...