Search results
Results From The WOW.Com Content Network
0.8–2 MPa 120–290 psi Pressure used in boilers of steam locomotives [citation needed] 1.1 MPa 162 psi Pressure of an average human bite [citation needed] 2.8–8.3 MPa 400–1,200 psi Pressure of carbon dioxide propellant in a paintball gun [64] 5 MPa 700 psi Water pressure of the output of a coin-operated car wash spray nozzle [58] 5 MPa ...
Pressure ; unit unit-code symbol or abbrev. sample default conversion gigapascal: GPa GPa 1.0 GPa (150,000 psi) megapascal: MPa MPa 1.0 MPa (150 psi) kilopascal: kPa kPa 1.0 kPa (0.15 psi) hectopascal: hPa hPa 1.0 hPa (0.015 psi) pascal: Pa Pa 1.0 Pa (0.00015 psi) millipascal: mPa mPa 1.0 mPa (1.5 × 10 −7 psi) millibar: mbar mbar 1.0 mbar (1 ...
Convert mmHg to SI units as follows: 1 mmHg = 0.133 32 kPa. Hence the normal blood pressure in SI units is less than 16.0 kPa SBP and less than 10.7 kPa DBP. These values are similar to the pressure of water column of average human height; so pressure has to be measured on arm roughly at the level of the heart.
The darcy is referenced to a mixture of unit systems. A medium with a permeability of 1 darcy permits a flow of 1 cm 3 /s of a fluid with viscosity 1 cP (1 mPa·s) under a pressure gradient of 1 atm/cm acting across an area of 1 cm 2. Typical values of permeability range as high as 100,000 darcys for gravel, to less than 0.01 microdarcy for ...
0.1 mPa is the lowest direct measurement of pressure that is possible with current technology. Other vacuum gauges can measure lower pressures, but only indirectly by measurement of other pressure-dependent properties. These indirect measurements must be calibrated to SI units by a direct measurement, most commonly a McLeod gauge. [22]
The CGS-to-SI correspondence of electromagnetic units as given was exact prior to the 2019 revision of the SI, until which the magnetic constant μ 0 was defined as 4π × 10 −7 N⋅A −2. As from the redefinition, μ 0 has an inexactly known value when expressed in SI units, with the exactness of the electromagnetic unit correspondence ...
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property.
For gases, pressure is sometimes measured not as an absolute pressure, but relative to atmospheric pressure; such measurements are called gauge pressure. An example of this is the air pressure in an automobile tire , which might be said to be "220 kPa (32 psi)", but is actually 220 kPa (32 psi) above atmospheric pressure.